panthera Freewheel User manual

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
Sid 1
ASSEMBLY INSTRUCTIONS
Art.nr. 8822135
Rev.2021-04
FREEWHEEL- KIT FOR BAMBINO 3
Assembly instructions for:
Freewheel-kit Bambino 3
art.nr. 4234224, 4234227, 4234230, 4234233
Tools needed:
A long Allen key 4 mm
A reinforcement bar is mounted underneath the footplate.
2) Remove screws (5) and screws
(6), and locks (7)
1) Fit screws (1) and washers (2)
with nuts (3) at the ends of the rein-
forcement bar.
3) Mount the bar underneath the
footplate with screw (5) in the
middle and screws (4 Fig. 1) on each
end.
1
3
2
6
75
1
23
4
44
5
4) Loosen the angle adjustment of the
footplate.
5) Loosely mount the strut (8) with clamp (9) and screw (11) on the
chassis.
8
9
10

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
Sid 2
6) Fasten the strut (8) in the foot plate with screw (11), washer (12) and nut (13) which is inserted in
the prepared slot in the rear of the foot plate. Adjust the angle of the footplate to the strut and tigh-
ten the screws on the clamp and footplate. Tighten the angle adjustment screws (Fig. 4) to 14Nm.
7) Cut a hole in the rubber mat
for Freewheel.
For setting /adapting read the Free-
wheel Users manual.
8
11
12
13 13
Mounting detalis for Freewheel
on Bambino 3 footplate
A) Medium straight shim 5,25
mm thick, cut to 105mm
B) Short ”rear end”
A
B