panthera Bambino 3 User manual

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
Sid 1
ASSEMBLY INSTRUCTIONS
Art.nr. 8822138
Rev.2021-01
SIDE GUARDS BAMBINO 3
1) Remove the rear wheels and place the
wheelchair upside down. Take one bracket,
left or right.
2) Put the bracket on the chassis as shown in
the picture and close the bracket. See explo-
ded view on page 3.
3) Fit screw M5x30 mm through the threaded
bushing, welded on the chassis. Tighten with
Allen key 3 mm.
Assembly instructions for:
Side guards Bambino 3
art.nr. 4235001, 4235002, 4235010
Tools needed:
Allen key 3 mm
Allen key 4 mm
4) Place the threaded bushing on it opposite
side.
5) Tighten securely with a 4 mm Allen key. 6) Take screw M5x16 mm. Put it in the other
hole and tighten rmly with a 4 mm Allen key.

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
Sid 2
7) Turn the wheelchair over, into upright posi-
tion.
8) Then mount the side guard in the bracket.
Repeat the procedure for the other side.
Adjust the side guard for 20, 22 or 24 ” wheels
The side guard can be adjusted to t di󰀨erent sizes of wheels. Parts 2 and 3 (see gure ??) are detachable to adjust the height of the sideguard to t desired
wheel size.
1. Use only part (1) for 20 ” wheels.
2. Use part (1 and 2) for 22 ”wheels.
3. Use part (1 and 2 and 3) for 24 ” wheels.