panthera Bambino 3 User manual

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
ASSEMBLY INSTRUCTIONS
art.nr. 8822126
Rev.2021-01
TRAY-TABLE AND MAGNETIC HOLD BAMBINO 3
Assemblu instructions:
Tray table and magnetic hold Bambino 3
art.nr. 6810000 Tray table
art.nr. 6810008 Magnetic hold
Max. load 5kg
Tools aquired:
Allen key 3 mm, Pliers
Cutter / scissors
Tray table Magnetic hold on rear wheel
6) Place the table brackets in the holes in the
side guards as shown in the picture and push
down to the bottom.
1) Width 24 cm. Use the inner holes for moun-
ting.
2) Width 27 cm. Use the outer holes for moun-
ting.
3) Width 30 cm. Use the inner holes for moun-
ting. Note that the brackets have changed places
between left and right compared to g 1 and 2.
4) Width 33 cm. Use the outer holes for moun-
ting. Note that the brackets have changed places
between left and right compared to g 1 and 2.
Placement of the brackets under the tray table for dierent seating widths of the wheelchair.
Letters ”A” and ”B” are stamped in the brackets. Table seen from below.
5) Turn the table over and screw in the screws.
Make sure that the screws are tightened into the
slot.

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
7) Place the magnetic hold centered on the
outside of the wheel. Rotate for each pair of holes
are located over two spokes.
If the wheels have spoke guards, rst you need
to drill 6 holes through the spoke guards (5 mm).
Center the magnetic hold on the spoke guard
and use as a template.
8) Thread the cable ties from behind to get the
eyelet to end up on the back of the bracket.
Tighten the tie holds hard. Cut the ends of the
cable ties. If the wheel has spoke guards, the
cable ties are pulled through both spoke guards
and the magnetic bracket.
9) Attach the tray table to the wheel by aligning
the magnets in the table and the hold on the
wheel.
Mounting of magnetic hold