Paradyne CopperJet 810 User manual

1
CopperJet 810 Mounting Bracket
Installation Instructions
Document Number 4800-A2-GN13-00
September 2002
The CopperJet 810 mounting bracket (Feature Number 4800-F1-013) can be used to
fasten the CopperJet 810 Bridge/Router to a wall, or to the side or underside of a desk.
Installing the Bracket on Wall or Side of Desk
Procedure
To attach the mounting bracket to a wall or to the side of a desk:
1. Fasten either side of the bracket to the wall or desk where the CopperJet 810 is to
be installed. Use screw anchors (not provided) in drywall or other soft materials.
02-17323

2
Installing the Bracket on Underside of Desk
Procedure
To attach the mounting bracket to the underside of a desk or other piece of furniture:
1. Fasten the top of the bracket to the surface the CopperJet 810 is to hang from.
02-17322

3
Installing the CopperJet 810 in the Bracket
Procedure
To install the CopperJet 810 in the bracket:
1. Connect all required cables to the CopperJet 810 before installing it in the bracket.
2. Slide the CopperJet 810 upward into the bracket with the faceplate against the
bracket.
3. Slide a cable tie (included) through the loops at the bottom of the bracket.
4. Fasten the cable tie and pull it tight.
02-17321

4
Document Feedback
We welcome your comments and suggestions about this document.Please mailthem to
Technical Publications, Paradyne Corporation, 8545 126th Ave. N., Largo, FL 33773, or
send e-mail to [e-mail]. Include the number and title of this document
in your correspondence. Please include your name and phone number if you are willing
to provide additional information.
Trademarks
All products and services mentioned herein are the trademarks, service marks,
registered trademarks, or registered service marks of their respective owners.
"
*4800-A2-GN13-00*
Copyright ©2002 Paradyne Corporation. Printed in U.S.A.