Paragon 7775 Deluxe Safe User manual

1
OPERATING MANUAL
7775 Deluxe Safe
DO NOT store your keys inside the safe
DO NOT discard instructions manual or keep inside safe
QUESTONS or PROBLEMS with your safe or need a replacement key, contact us at:
www.teamcustomerservice.com
Enter Key Code: _________________________________________________. This code is found
on the edge of the “emergency lock”and reads“8####”

2
Lock & Safe ED keypad operating manual
DIRECTION FOR USE
BEFORE USING YOUR SAFE
1. Remove the key hole cover on the key
pad.
2. Insert the key and turn
counter-clockwise to unlock the safe.
3. Turn the handle clockwise to open the
door.
INSTALLING THE BATTERIES
1. Remove the battery cover plate located
on the inside of the door.
2. Install 4 AA alkaline batteries provided.
3. Replace the battery cover.
NOTE: If both the red and green lights are on while the safe is open, this indicates that the
batteries are low and need to be changed.
SETUP, CHANGE OR RESET YOUR USER CODE
1. With the door open, locate the red button on the back of the door
near the hinge.
2. Press the red button and listen for the beep.
3. Enter your new user passcode (3-8 digits long)
4. Immediately after entering your passcode press the “A” or “B”
button on the keypad. Your new user passcode is now stored.
NOTE: This safe store up to 2 passcodes (a user code and a manager
code). Entering a third code will erase the first passcode entered.
SETUP OR CHANGE A MANAGER PASSCODE
1. Open the safe with the passcode you wish to change and leave the door ajar.
2. Press the “0” button on the keypad twice. Press the red button, listen for a beep and then
enter your new user passcode.
New user passcodes may be 3-8 digits long.
3. Immediately after entering your new code, press the “A” or “B” button on the keypad. Your
user code is now changed.
OPENING THE SAFE
1. Input your code and then press the “B” button, the green light will turn on.
2. Turn the knob clockwise within 5 seconds to open the door.
3. Each key pressed will be accompanied by a buzzer and a yellow flashing light. If the entered
code is invalid the yellow light will flash and the buzzer will quickly sound, this indicates the code
needs to be re-entered.
CAUTION: Entering an incorrect code (3) times will lock the system for 20 seconds.
CLOSING THE SAFE
1. Turn the knob counter-clockwise, the mechanism will automatically lock the safe.
IMPORTANT! Your safe comes with 2 separate sets of keys, one for the exterior door and one for the
interior locking cabinet.

3
IMPORTANT WARNINGS
DO NOT KEEP YOUR EMERGENCY OVERRIDE KEYS INSIDE THE SAFE.
GUN WARNING: This product is not intended for the secure storage of all materials. Items
such as firearms, other weapons, ammunition, combustible materials, or medication
should NOT be stored in this unit. Your safe is only part of your total security
protection.
Lock & Safe recommends that you store your safe in a closet, office, basement,
bedroom or any other location that are convenient for you but out of direct line of sight
from prying eyes. The location of the safe does not affect the safe’s ability to protect
your valuables inside.
IMPORTANT
If you experience any problems with your safe, please contact us at
www.teamcustomerservice.com