Paramount Fitness ES-207-BK User manual

Contact us by email at [e-mail] or call us toll free at [phone],
7:30 a.m. - 4:00 p.m., PT, Monday - Friday
REV18-01
ITEM # - ES-207-BK
MODEL # - BLT-999B-9
Installation and Operation Instructions

Contact us by email at [e-mail] or call us toll free at [phone],
7:30 a.m. - 4:00 p.m., PT, Monday - Friday
Control Buttons/Functions
Listing Approvals
Operating Instructions
Important Safety Instructions 2-3
5
4
7
6
Maintenance
Trouble shooting 8
1
Warranty 9

2
CONSUMER SAFETY INFORMATION
Read this manual before installing and operating this appliance.
Failure to follow these instructions may result in electric shock, fire property
damage, personal injury and will void the warranty.
Requires the use of Fireplace Mantel.
Do not store or use gasoline or other flammable liquids or vapors in the vicinity
of this appliance.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock and injury to persons including the following:
1. The manufacturers instructions completely before using this appliance.
2. Thisappliance will become hot when in use. To avoid burns, do notlet bare skin touch
hot surfaces. The grill at the top of this heater in particular will become hot when the heater
is active. Keep combustible materials such as furniture,pillows, bedding, paper, cloth,
curtains, etc. at least 3 feet (0.9meter) away from the frontofthe appliance. Keep all items
away from the sides and back of the appliance and take special care not to block the air
intake or exhaust vents.
3. Extreme caution is necessary when the appliance is used by or near children or invalids
and whenever the heater is left operating and unattended.
4. Do not operate the heater if the power cord or plug has been damaged or the heater
has been damaged or malfunctioned in any way. Take the appliance to an authorized
service facility for examination, electrical or mechanical adjustment or repair.
5. Do not use outdoors.
6. Do not use the appliance in bathrooms, laundry rooms or other similar indoor
locations where it may contact water. Never locate the appliance where it may fall into a
bathtub or other water container.
7. Do not run thepower cord under carpeting. Do not coverthe power cord with throw
rugs, runners, or similar floor coverings. Take care to position the cord away from high traffic
areas and such that it can't be tripped over.
8.
To disconnect the appliance, turn all controls "OFF", and then remove the plug from the
electrical outlet.
9. The appliance comes equipped with a 3 prong-grounding plug. Do not attempt to cut the
grounding prong. Connect to properly grounded 120V outlets only. This appliance, when
installed, must be electrically grounded in accordance with local codes or, in the absence of
10. Do not insert or allow foreign objects to enter any ventilation or exhaust openings as
this may cause an electric shock or fire, or damage the appliance.
11.
To prevent a possible fire, do not block air intakes or exhausts in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
local codes, with the power current.

SAVE THESE INSTRUCTIONS
3
12. All electrical heaters havehot and arcing or sparkingparts inside. Do not use in areas
where gasoline, paint, or flammable liquids are used or stored or where the appliance will
be exposed to flammable vapors.
13. Avoid using the appliance with an extension cord. Extension cords may overheatand
cause a risk of fire. If an extension cord MUST be used, the cord must be No.16 AWG
minimum size and rated not less than 1875 Watts. The extension cord must be a 3-prong
cord with grounding type plug and cord connection and should not exceed 20' (6m) in
length.
14. Whentransporting or storing the heater, take care to keep both the unit and power cord
/ plug dry, freefrom excessive vibration and away from heat sources.
15.Use theheater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
16. Do not attempt to burn wood or other materials in this heater.

LISTING APPROVALS
This heater has been tested in accordance with the CSA Standards.
Model Number: XFRST2029-1
ecalperiFcirtcelE:noitpircseD
Voltage: 120V AC, 60Hz
Watts: MAX 1500W
Length: 19.7
Height: 28.9
Depth: 12.6.
4

OPERATING INSTRUCTIONS
Read all instructions and warning prior to operating the appliance.
Ensure that all control are in the "OFF" position before plugging the appliance into a
properly grounded electrical outlet.
The main switch is located at the top left corner on the front(see Figure 1)
The main control buttons are located at the top right corner on the front(see Figure 1)
FIGURE 1
CARE AND CLEANING OR MAINTENANCE
Turn heater OFF and unplug from electrical outlet before any cleaning or maintenance is
.demrofrep
Keep combustible materials,such as furniture,pillows,bedding,papers,clothing,and curtains
at least 3 feet away from fireplace.
Use a vacuum or duster to keep heat and vent area from dust and dirt.The exterior of the
fireplace shouldbe cleaned with a damp cloth or duster.Do not use abrasive cleaners or
liquid sprays.
Warning: Any other servicing should be performed by an authorized service representative.
Master Power Button
Control Buttons
5

CONTROL BUTTONS/FUNCTIONS
1. Plug in your electric fireplace.
2. Make sure the main power ON/OFF
switch is ON! The remote control will
NOT work if the main power switch is
OFF.
3 When operating the remote control, it
must be pointed towards the front of the
unit.
4. The ON/OFF button at the below right of the
remote is the main ON/OFF power button
(Figure 5). Pressing this button activates
the power to the unit.
5 Presss the button to cycle through LO, HI
and OFF.
6 To adjust the flame height and ember bed
brightness, press the “ ”or “ ” buttons.
To increase the flame height and ember
bed brightness, press the “ ” button. to decrease
the flame height and ember bed brightness,the“ ”
button.There are five levels of flame effects.
7. Press the “ ” button to set timer .
8. To turn off the fireplace, press the
ON/OFF button once. NOTICE: This
remote control must remain within 8
meters or 26 feet of the fireplace to be
effective.
OPERATING BY REMOTE CONTROL
6
The manual controls are located on the bottom of the fireplace.
You have the following controls:
1. Power ON/OFF: Power to the unit
2. Flame brightness controls: Allows you to adjust
the flame to suit your mood.Press to
increase flame brightness and to decrease
flame brightness.You must press the button
Several times to see the full flame effect.
3. Low heat:800 watts
4. High heat: 1500 watts
Please note: The heater touch panel control must be
pressed 2 times to achieve high heat.
5. Heater Timer: Allows you to leave your heater
on while you sleep with an automatic timer for
shut off. You can set your heater to be on for
1 /2 hour increments starting at a 1/2 hour up to
a maximum of 7-1/2 hours一press once for each
1 /2 hour increment. Afteryou reach 7-1/2 hours
the next press will shut off the feature.

MAINTENANCE
Flame effect/Light bulb replacement:
Allow the electric fireplace insert to cool before attempting to replace light bulbs. The
flame effect on this electric fireplace insert is created by illuminating(2) clear 120V 40watt
E-12(small base, chandelier candle type)light bulbs. The life of the light bulbs willdepend
on how often the fireplace is used. Do not use light bulbs that exceed 40 watts per bulb.
1. Turn power to off and unplug insert from electrical outlet before changing light bulbs.
2. Slide fireplace mantel away from wall to gain access to back of fireplace.
3. Locate access panel on back of insert.
4. Using a Phillips screwdriver, remove screws in access panel. Open door and replace
light bulbs as necessary. It is recommended that both bulbs be replaced at the same
time.
5. Follow steps 1 through 4 in reverse order to reinstall access panel.
NOTE:
NOTE: We do not supply replacement light bulbs. They can be purchased at many
home centers or hardware stores.
WARNING: Before attempting to perform any maintenance on this appliance, turn all controls
to the "OFF" position and unplug the heater. Allow the appliance to be "OFF" for at least
10 minutes before performing any maintenance in order to allow all components to cool
properly.
7

Care and maintenance:
Turn heater OFF and unplug from electrical outlet before any cleaning or maintenance is
performed.
Keep combustible materials such as furniture, pillows, bedding,papers, clothing, and
curtains at least 3feet (0.9meter) away from fireplace.
Use a vacuum or duster to keep heat and ventarea clean from dust and dirt. The exterior
of the fireplaceshould be cleaned with a damp cloth or duster. Do notuse abrasive
cleaners or liquid sprays.
Warnings and cautions:
WARNING To avoid electrical shock never open the back panel of the until the
power has been turned off, and the insert unplugged.
WARNING Any electrical repairs to this electric fireplace, should only be performed by a
qualified technician.
WARNING Any electrical wiring repairs should only be performed by qualified electrician,
and also must comply with local building codes.
WARNING Discontinue use of this electric fireplace if any of the follow has occurred:
Water damage, if insert has been dropped or dented, if power cord has become broken, if
power cord becomes hot to touch, if unit smokes or smells like smoke.
Note:Whenthe heat function is used for the first time, a slight odor may be present. This
is normal and should not occur again unless heater is not used for extended periods of
time anddust is allowed to accumulate on heater element.
TROUBLE SHOOTING
PROBLEM POSSIBLE CAUSE
1.No power, no indicator lights Insert was not plugged in Make sure that power cord is plugged
into 120V outlet
2.No power, no indicator lights No power at outlet Check circuit breaker or fuse
3.Power indicator lights come on,
logs will not glow and no flame effect
Broken or burned out light
bulbs
Follow instructions for replacing light
bulbs
4.Log glow, but no flame Flame spinner disconnected Call customer service for instructions
5.Flame and logs glow, but no heat Heater switch is off Push heater button. Indicator light will
come on
6.Heater and /or flame turn off while
operating
Timer function may been on Push On/Off button to reset
WARNING:Turnoffthe appliance, unplug and let cool for at least 10 minutes before
attempting
attempting to service. Only a qualified professional should mpt attempt to service or repair the
appliance.
CORRECTIVE ACTION
8

IMPORTANT
For questions, concerns or problems with our product please
email our customer service department:
[email protected]
DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE
WARRANTY
This product is inspected, tested and carefully packaged to minimize
the chance of damage during shipment. If a part (excluding light
bulbs, glass and fuses*) within one year from the date of purchase
proves to be defective in material or fabrication under normal use,
the part will be repaired or replaced. The Company’s obligation under
the warranty is to replace or repair defective parts at our discretion.
Any expenses or damage resulting from the installation, removal or
transportation of the product will be the responsibility of the owner
and are not covered by this warranty. The owner assumes all other
risks arising from the use or misuse of the product. The warranty will
be void if the product damage or failure is deemed by the Company
to be caused by accident, alteration, misuse, abuse, incorrect
installation or removal, or connection to an incorrect power source
by the owner. The Company neither assumes, nor authorizes any
person or entity to assume for it any obligation or liability associated
with its products. Light bulbs and fuses are not covered under this
warranty. If you have any questions regarding the warranty or
service, please contact us at [email protected].
Customer Service :
JR Home Products
Unit 306 - 19100 Airport Way, Pitt Meadows, BC V3Y 0E2
Toll Free : 1-800-561-5550
E-mail : [email protected]
Warranty Registration Information Form / Formulaire d’enregistrement de la garantie
Registration can be completed online at
www.jrhome.com or by mailing this form.
Name / Nom :
Street / Adresse :
City / Ville :
Province / Province :
Postal Code / Code postal :
Daytime Phone # / No téléphone jour :
Evening Phone # / No téléphone soir :
E-Mail Address / Courriel :
Product/Produit :
Place of Purchase / Lieu de l’achat :
Date of Purchase / Date de l’achat :
Model # / No de modèle :
Serial # / Numéro de série :
You MUST register your product to receive
warranty service.
For warranty service, contact J&R Home
Products at the address, phone numbers listed
below within 30 days of purchase. Be sure to
have your sales receipt and original date of
purchase. All warranty service will be
coordinated by
J&R Home Products service center.
Vous DEVEZ enregistrer votre produit pour vous
prévaloir de la garantie.
Afin de faire valoir la garantie, communiquez
avec J&R Home Products à l’adresse et aux
numéros indiqués ci-dessous dans les 30 jours
suivant la date d’achat. Ayez en main votre reçu
et la date d’achat. Toutes les demandes liées
aux garanties seront traitées par le centre de
service de J&R Home Products.
Please mail to / Veuillez poster le tout à : Parts & Service Department, J&R Home Products Ltd. Unit 306 - 19100 Airport Way, Pitt Meadows, BC V3Y 0E2
You MUST register your product within 30 days of
purchase to receive warranty service.
Si vous éprouvez si vous avez des questions ou des
préoccupations, prière de faire parvenir un courriel à notre service à la clientèle
[email protected]
UNE PREUVE D’ACHAT DATÉE EST REQUISE POUR SE PRÉVALOIR DE LA GARANTIE.
AVERTISSEMENT
soigneusement
des verres,
s
demeurent
service,
contacter le service à la clientèle à : [email protected].
Service à la clientèle:
JR Home Products
Unit 306 - 19100 Airport Way, Pitt Meadows BC V3Y 0E2 Numéro
sans frais: 1-800-561-5550
Courriel: [email protected]
Vous DEVEZ enregistrer votre produit dans les 30 jours suivant l'achat
pour bénéficier du service de garantie.
L’enregistrement sera complet une fois que vous aurez postéce
formulaire ou que vous serez inscrit en ligne.
120920
9