Parker F11 series User manual

7 ParkerHannin
PumpandMotorDivision
Trollhättan,Sweden
ServiceManual
Series F11
BulletinHY30-5503-M1/UK
Assembling
1.Placetheringgearontheshaft
withtheguidepinlocatedagainstthe
guidehole.
2.Pressdownthebigtaperedroller
bearingtogetherwiththeringgear.
3.Placethedistanceringonthebig
taperedrollerbearing.
4.Placethesmalltaperedrollerbear-
ingontheshaftasonthepicture.
5.Pressdownthesmalltaperedroller
bearinginsmallstepsuntilcorrect
preloadisachived.Nottotightandno
backlash.
6.Placethelockwasher(s)ontothe
shaft.

8ParkerHannin
PumpandMotorDivision
Trollhättan,Sweden
ServiceManual
Series F11
BulletinHY30-5503-M1/UK
Assembling
7.Assembletheroundnutandtighten
ituntiloneopeningisincorrectposi-
tionforthelockwasher.
10.Assemblethecylinderbarrel.
Instructions on page 11.
8.Securetheroundnutasshownin
thepicture.
11.AssembletheO-ringsonthedis-
tancering.
9.Assemblethevalveplate.Make
suretheslotisincorrectpositionand
thevalveplateislocatedasshownin
picture.
12.Carefullytapdownthedistance
ringtothebarrelhousing.Lubricate
themwithoilbeforeassembly.

9 ParkerHannin
PumpandMotorDivision
Trollhättan,Sweden
ServiceManual
Series F11
BulletinHY30-5503-M1/UK
Assembling
13.Assembletheshims.
14.Assemblethepistons.Lubricate
theballsocketsbeforeassembly.
15.Assembletheshaftpackagewith
pistonsintothecylinderbarrel.
16.Makesurethetimingiscorrect.
17.Carefullytapdownthebearing
housing.
18.Lubricatethesealingsurfaceon
theshaftbeforeassemblingtheshaft
seal.