Patio Post EA53024 User manual

ASSEMBLY INSTRUCTION
ITEM CODE: EA53024
3 Piece Outdoor Set
Page 1
For any assistance with assembly or for missing parts please Contact with us
Email: patiopos[email protected]
Web: www.lhgst.com
Adress:NO.99 South Heyang Road,Dayang Street, Linhai,zhejiang,China

Page 2
PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that
may damage the product
2.Take care when lifting. Product should be assembled as near as possible
to the point of use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning
assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the
threads
7.Assembly is to be carried out by a competent adult(s) ONLY
8.During assembly, children should be kept away from the product due to
possible risk to injury.
9.Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.

Page 3

Page 4
Step 1
You will need
•Prepare a surface with a blanket or cardboard.
•Connect the 2 side cover (E,F) to the front and
back cover(C,D), as shown below.
•Secure with bolt(K), threaded from the outside,
and Lock the inside with washer(L) ,Fasten with
Allen key(M).
•Do this for all 8 connection points.

Page 5
Step 2
You will need
•Place the storage box upside down on the prepared surface .
•Prepare 10x bolt K sets by threading bolt(K) through washer(L).
•Connect the bottom cover(B) to the box as shown below.
•Secure with bolt K sets, fasten with Allen key(M).
•Do this for all 10 connection points.

Page 6
Step 3 You will need
•Put the storage box right-side up on the prepared surface .
•Connect the cover(A) to the frame, as shown below.
•Secure the cover with 3x bolt(H) at each hinge, threaded from
the top, down. Lock the underside with washer(L) and nut (J).
Fasten with Allen key(M), whilst holding the nut with a pair of
pliers.
•Do this for all 3 connection hinges.

Page 7
Step 4 You will need
•Attach the steam rod to the area between the cover (A) and
finished part, note the side without plastic are apply to cover
,as shown below.
•Secure the steam rod with bolt(H), threaded from the upside
of the hinge, and Lock the inside with washer(L) and nut
(J),Fasten with Allen key(M). You will need to bolts per end.

Page 8
Step 6
Assembly is complete

Page 9