PB TEEN Bella Get Ready Vanity User manual

www.pbteen.com
Bella Get Ready Vanity
Pre-Assembly:
•Please read all instructions before beginning assembly.
•Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
Parts Included:
A - Top – 1 pc B - Leg – 4 pcs C - Removable Tray – 1 pcs
Hardware Enclosed:
D - Cord Set – 1 pcs E - Wood Screw – 2 pcs
(4 x 15 mm)
Tool Required:
Phillip Head Screwdriver (Not included)
Assembly Instructions:
1. Lay the Top (A) upside down on a carpet or the foam in shipping box. Use caution when turning table over
as the center flip panel comes with a mirror.
2. Attach four Legs (B) by inserting the hangers bolt into the inserted nuts at corners of the Top (A). Turn
clockwise to tighten.
BB
B
B
A

www.pbteen.com
3. Carefully turn the vanity right side up. Flip up thecenter panel. Place the CordSet (D) into the cut out near
back of Top (A). Secure with Wood Screws (E) by a Phillip Head Screwdriver.
D
E
E
4. Insert the Removable Tray (C) onto the open space of Top (A).
5. If the vanity doesn’t sit level.Adjust the levelers under its legs.
C
Tray Stopper
Pre-attached Leveler
Leg
Note:
The hinge may loosen after a period time and the center panel may close
fast and not stop at half way, as it should. Use a Phillips Head Screwdriver
and turn the hinge’s screw clockwise to make it work properly.
Assembly is completed.
Care Instructions:
•See the caution on the Cord Set (D) before using
•Dust often with a soft, dry cloth.
•To clean, slightly moisten cloth with water (a damp cloth will hold dust and prevent scratching; dry
thoroughly).