baby&child Antique Steamer Trunk Wide Dresser User manual

ANTIQUE STEAMER TRUNK WIDE DRESSER
TOOLS NEEDED
Phillips head screwdriver (not included)
CUSTOMER SERVICE
If you are missing parts or have any questions about this product please contact us at : 1-800-762-1751
WARNING
CARE INSTRUCTIONS
1. Dust often using a clean, soft, dry lint-free cloth.
2. Blot spills immediately.
3. We do not recommend the use of chemical cleansers, abrasives, or furniture polish.
WARNING : ADULT ASSEMBLY ONLY OWING TO THE PRESENCE
OF SMALL PARTS, SHARP POINTS AND EDGES
!
Young children may be injured by tipping furniture so proper installation of the mounting hardware for this item is highly
recommended. When properlry installed, this mounting hardware could provide protection against the unexpected tipping
of the furniture piece. This product is only a deterrent. It is not a substitute for proper adult supervision.
1
2
3
4
5
6
Screw 1 ½”
2 pcs.
Screw
⅝”
2 pcs.
Steel Cable 1 pc.
Hair Pin
Pin
Bracket
2 pcs.
2 pcs.
2 pcs.
NO. ITEM DESCRIPTION QTY.
Page 1 of 2

www.rhbabyandchild.com
Thank you for your purchase
1 2
3 4
FURNITURE TIPPING RESTRAINT INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
1. Determine the final position of the furniture piece. Fix one of the brackets horizontally onto the center back side of the
furniture piece. Attach to furniture on the leather trim area with the 5/8” screws. See Figure 1 below.
2. Drill starter holes into the wall stud at the level of the bracket on the furniture piece. See Figure 2. Always attach to
stud wherever possible. Fix the bracket to the wall stud using the 1 ½”screws.
3. Move furniture piece in line with bracket installed on the wall. Place one end of the steel cable through each of the
brackets and insert the pins as shown in Figure 3. Make sure that the pin goes through the holes of the steel cable and
both holes of the bracket.
4. Install hairpins into holes at bottom of each pin.
Page 2 of 2