PB TEEN Chelsea User manual

1/2
www.pbteen.com
Chelsea 6 Drawers Dresser
PRE-ASSEMBLY :
•Please read all instructions before beginning assembly.
•Two-adult assembly is recommended.
•Save all packing materials until assembly is complete to avoid accidentally discarding
smaller parts or hardware.
PARTS INCLUDED:
A – Dresser (1pc)
B – Legs (4pcs)
C – Center Leg (1 pc)
D – Metal Knobs (12 pcs)
E – Metal Knobs Bolt (12pcs)
TOOLS REQUIRED (but not included):
Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS:
1. On a soft, scratch-free surface, such as a carpet or rug, remove all the parts from the boxes.
2. Determine the desired location of the Dresser (A). Insert the exposed screw of the Legs (B) into the pre-
drilled hole on bottom of each corner of the Dresser (A). Insert the exposed screw of the center leg (C)
into the drilled hole on the center bottom of the Dresser; turn clockwise until tight.
3. To attach the Metal Knobs (D) to the drawers hold Metal Knobs (D) over pre-drilled hole in drawer front,
screw the Metal Knob Bolt (E) through the interior of the drawer and into the Metal Knobs (D); tighten
using a Phillips Head Screwdriver.
CARE INSTRUCTIONS:
•Avoid direct sunlight and excessive temperatures
•Dust often using a clean, soft, dry and lint-free cloth
•Waxing is not recommended on lacquered finish
A
B
C
DE

2/2
www.pbteen.com
Furniture Tipping Restraint
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.
•Manufacturer assumes no liability for improper installation or excessive loads placed on screws, brackets
or straps.
•People may be injured by tipping furniture and the use of a tipping restraint is highly recommended.
•When properly installed, this restraint could provide protection against the unexpected tipping of furniture.
•To function properly, the wall-side of the restraint must be secured to a wall stud or equally strong
material.
HARDWARE INCLUDED:
A - (2) Brackets B - (2) Long screws (38mm.)
C - (2) Short screws (20mm.) D - (1) Nylon strap
INSTALLATION INSTRUCTIONS:
1. Locate a wall stud behind your furniture. Position a Bracket (A) on the stud approximately 1” below the
top of the furniture. Mark and drill pilot hole into the center of the stud with a 3/32” drill bit. Attach a
Bracket (A) to the stud with the Long Screws (B) provided.
2. On the back of the furniture, the second Bracket (A) will need to be attached to the furniture frame at the
top.To do this, temporarily move the furniture into its final position and mark the location of the wall’s
Bracket (A) on the furniture frame with a pencil.
3. Move the furniture away from the wall and place a Bracket (A) on the mark. Using the marks from the
previous step as a guide, drill holes for screws with a 3/32” drill bit. Attach the bracket to the furniture with
the Short Screws (C) provided.
4. Move the furniture into its final position, taking care to line up the wall bracket with the furniture bracket.
Thread the Nylon Strap (D) through the Bracket and cinch as shown in the illustration. Tighten strap until
snug. Do not overtighten.
Top
Wallboard