PB TEEN Hannah Bed Queen User manual

1 of 3
www.pbteen.com
Hannah Bed Queen Size
PRE-ASSEMBLY:
•Please read all instructions before starting to assemble.
•Two-person is recommended during assembly.
•Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
PARTS INCLUDED:
A – Headboard – 1 pc B – Footboard – 1 pc C – Leg – 4 pcs
D – Siderail – 2 pcs E – Slat Rolls – 1 pc F – Support Leg– 3 pcs
HARDWARE INCLUDED:
G – Phillips Head Screw – 14 pcs
TOOLS REQUIRED (but not included:
•Phillips head screwdriver

2 of 3
www.pbteen.com
ASSEMBLY:
1. Attach Leg (C) to the Posts of Headboard (A) and/or Footboard (B) by inserting exposed bolt at the top of Leg (C)
into the bottom of Posts and turning legs to tighten, as shown below. Repeat leg assembly for other Posts.
2. Determine desired location of bed. Hold the Headboard (A) in a vertical position tilted slightly forward. Attach
each Siderail (D) to the Headboard (A) by inserting the hooked ends of the Siderail (D) into the corresponding slot
in the Headboard (A). Push down firmly on the top of the Siderails until they sit themselves over the pins inside
the legs slots, as shown. Be sure the small ledge on each Siderail (D) is facing inward.
3. Repeat Siderail (D) assembly with Footboard (B).
4. Lay the Slats Roll (E) in between the Siderails (D). Using a Phillip Head Screwdriver, loosely fasten the Slats Roll
(E) to the Siderails with Phillips Head Screws (G). Once all Phillips Head Screws (G) are in place, fully tighten
them.

3 of 3
www.pbteen.com
5. Thread the Support Legs (F) with levelers into the pre-drilled holes on the bottom of the slat on Slats Roll (E).
NOTE: Three positions for the support legs on Slats Roll (E) are provided. The center positions of each slat are for
bed use without trundle. If using a trundle bed, please thread support legs into pre-drilled holes on the opposite side
of the bed to where you desire the trundle to be used. This provides enough room for the trundle not hitting the
Support Legs (F).
6. Adjust recessed levelers located at the bottom of each Support Leg (F), turning the levelers until adequate contact
is made with the floor.
7. Periodically tighten all connections.
CARE INSTRUCTIONS:
•Avoid direct sunlight and excessive temperatures.
•Dust often using a clean, soft, dry and lint-free cloth.
•Slightly moisten cloth with water. A damp cloth holds dust and prevents scratching.
•Waxing is not recommended on lacquered finish.