PB TEEN Style-It Tall Bookcase User manual

1/2 pages
www.pbteen.com
Style-It Tall Bookcase
PRE-ASSEMBLY:
•For your safety and ease, assembly by two adults is recommended.
•Read all instructions before beginning assembly.
•Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping
box provides and ideal work surface. Do not dispose of any contents until assembly is completed to avoid
accidentally discarding small parts or hardware.
•Do not use power drill as it may cause cracking.
PARTS INCLUDED: HARDWARE INCLUDED:
A – Tall Bookcase (1pc) C – L-Bracket (8pcs)
B – Shelf (2pcs) D – Wood Screw 3 x 12mm (8pcs)
TOOLS REQUIRED (but not included):
Phillips Screwdriver
ASSEMBLY INSTRUCTIONS:
1. Insert L-Bracket (C) into the corresponding pre-drilled holes on interior side panels and place Shelf (B) on L-
Bracket (A) as shown below in Figure 1.
2. To secure the shelf in place, insert Wood Screws (D) from the underside of shelf through the L-Bracket (C) using
a Philips Screwdriver to tighten as shown below in Figure 1. NOTE: Both shelves must be securely attached to L-
Brackets (C) before use.
CARE INSTRUCTIONS:
•Dust with a clean, soft cloth.
•Avoid the use of chemicals and harsh cleaning agents.

2/2 pages
www.pbteen.com
Style-It Bookcase Large
FURNITURE TIPPING RESTRAINT
Young children may be injured by tipping furniture. The use of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection against the unexpected tipping of furniture due to
small tremors, bumping or climbing. We recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.
HARDWARE INCLUDED:
W - Bracket – 2 pcs Y - Long Screw – 2 pcs
X - Short Screw – 2 pcs Z - Nylon Strap – 1 pc
INSTALLATION INSTRUCTIONS:
1. Locate a wall stud behind your furniture. Position a Bracket (W) on the stud approximately 1” below the top of
the furniture. Mark and drill pilot hole into the center of the stud with a 3/32” drill bit. Attach a Bracket (W) to the
stud with the Long Screws (Y) provided.
2. On the back of the furniture, the second Bracket (W) will need to be attached to the furniture frame at the top.
To do this, temporarily move the furniture into its final position and mark the location of the wall’s Bracket (W)
on the furniture frame with a pencil.
3. Move the furniture away from the wall and place a Bracket (W) on the mark. Using the marks from the previous
step as a guide, drill holes for screws with a 3/32” drill bit. Attach the bracket to the furniture with the Short
Screws (X) provided.
4. Move the furniture into its final position, taking care to line up the wall bracket with the furniture bracket.
Thread the Plastic Restraint (Z) through the bracket and clinch as shown in the illustration. Tighten strap until
snug. Do not over tighten.
WY
X