PB TEEN Lilac User manual

Lilac Bed Twin & Full Size
Pre-assembly:
•Please read all instructions before starting to assemble.
•Two adults are recommended during assembly.
•Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
www.pbteen.com
Parts included:
A – Headboard - 1 pc. B– Footboard - 1 pc.
C – Slat Roll - 1 set.
D – Siderail - 2 pcs.

Hardware Included:
E– Wood Screw - 32 pcs.
www.pbteen.com
Tools required but not included:
Phillips Head Screwdriver
Assembly:
1. Hold the Headboard (A) in a vertical position tilted slightly forward. Attach each Siderail (D) to the Headboard (A)
by inserting the hooked ends of the Siderail (D) into the corresponding slots in the Headboard (A), as shown
below. Push down firmly on the top of the Siderails (D) until they seat themselves over the pins inside the legs
slots. Be sure the small ledge on each Siderail (D) is facing inward. There are two levels for the Siderails (D). If
you plan on using a trundle, please use the highest setting.
2. Repeat with the Footboard (B).
3. Lay the Slat Roll (C) down on the inner ledges of the Side Rails (D). Using a Phillips Head Screwdriver, fasten the
Slat Roll (C) to the Siderails (D) with the Wood Screws (E). Insert the Wood Screw (E) though the pre-drilled holes
on the Slat Roll (C) and into the Siderails (D). Loosely tighten. Once all screws are in place, fully tighten.
Periodically tighten all connections. Adjust the recessed levelers located at the bottom of each leg to keep the
whole assembly level.
Care Instructions:
•Avoid direct sunlight and excessive
temperatures.
•Dust often using a clean, soft, dry and lint-free
cloth.
•Slightly moisten cloth with water. A damp cloth
holds dust and prevents scratching.
•Waxing is not recommended on lacquered
finish.