Pearl BD-10 User manual

Components
• Base Assy w/Pad (x1)
• Support Bar (x1)
• Key Bolt w/Washer (x3)
• Drum Key (x1)
Fig.1 Fig.2
Congratulations on your purchase!
For optimum performance, please read this Instruction Manual before playing.
BD-10
PEARL BASS DRUM PRACTICE KIT
Instruction Manual
1. Partially raise the Pad on the Base Assembly and
turn it on its side to rest on a stable flat surface.
Next, place the Support Bar with the angled end
under the base assembly. Insert a Key Bolt with
Washer through the Support Bar into the threaded
hole in the Base. Slightly tighten by turning the Key
Bolt clockwise (Fig.1). Do NOT fully tighten the Key Bolt.
2. Turn the Base Assembly upright and raise the Pad to
line the bolt holes in the Support Bar to the
corresponding holes on the back of the Pad (Fig.2).
Assembly Instructions
Drum Key
Support Bar
Anchor Screw
Pad
Adjustable Clamp Plate
Wing Bolt
Support Bar
Washer
Key Bolt
Support Bar
Pad

https://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in Taiwan
-Oct 2020-
Fig.3
Fig.5
Fig.4
The Anchor Screws are Sharp; please take
care when handling the product.
For best results, use on carpeted surfaces
only.
Use on hard flooring may result in damage to
the floor surface from the Anchor Screw
sharp tip. Check to ensure the Anchor Screws
are always retracted when used on these
surfaces.
Periodically check all Wing Bolts and Key
Bolts to ensure they are tight.
Suggested Use
To use the BD-10, place it on a flat surface and adjust the
Anchor Screws by extending them downward to prevent
creeping. We also suggest using the Anchor Screws of
the Bass Drum Pedal if needed.
CAUTION
3. Insert both Key Bolts with Washers through the
Support Bar into the threaded holes located on the
back of the PAD and finger tighten (Fig.3).
4. Next, firmly secure the Support Bar to the Pad and
Base by tightening all three Key Bolts using the
Drum Key supplied (Fig.1 & Fig.3).
1. Loosen the Wing Bolts by turning them counter-
clockwise on both sides of the BD-10 Adjustable
Clamp Plate (Fig.4).
2. Next, loosen the Bass Drum Pedal Hoop Clamp
Wing Bolt by turning it counterclockwise (Fig.5).
Note: Bass Drum Pedal Hoop Clamps vary in style
depending on the model.
3. Place the Bass Drum Pedal Hoop Clamp onto the
BD-10 Adjustable Clamp Plate and firmly attach the
Pedal by tightening the Pedal Hoop Clamp Wing
Bolt clockwise (Fig.5). Check to ensure the Bass
Drum Pedal is secure.
4. Tighten the BD-10 Adjustable Clamp Plate Wing
Bolts by turning them clockwise (Fig.4). Check to
ensure they are evenly tight and secure.
Mounting a Bass Drum Pedal to the BD-10
Anchor Screw
Support Bar
Washer
Key Bolt
Wing Bolt
Hoop Clamp
Wing Bolt
Adjustable Clamp Plate
Wing Bolt
Anchor Screw
BD-10
Bass Drum Pedal