peerless-AV ACC 316 Guide

ISSUED: 01-30-07 SHEET #: 009-9037-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
1 of 4
Parts List
DESCRIPTION QTY.
Atri-bar belt clip 2
Bbeltguides 2
Cbelt with cinch buckle 1
Dbelt without buckle 1
Eclear strips 2
D
C
A
E
B
Begin by connecting belt with buckle (C) to belt without buckle (D).
CC
DD
B
AA
B
Continue by sliding on one belt guide (B) and one tri-bar belt clip (A) on each side of the buckle. Refer to drawing
below.
A
TOP
BOTTOM
NOTELINES
FACES UP
Model:ACC316
Some parts may appear slightly different than illustrated.
Installation&Assembly-Safety Belt

ISSUED: 01-30-07 SHEET #: 009-9037-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
2 of 4
Withtheelectronic componentdismounted,place belt assemblyoverelectronic component andreposition the
components according to dimensions in drawing below. Note: keep buckle closer to left side of the electronic
component to allow for movement when tightening belt assembly. Trim off the end of the belt if necessary, then lightly
burn the end of the belt to prevent fraying. Repeat step 3 for the other side of the electronic component.
6”
A
B
Make sure that electronic component surface is clean of grease, oil and dust. Once all components are in place,
remove sticker from bottom of belt guides and firmly press them onto the electronic component.
12”
2”
electronic component

ISSUED: 01-30-07 SHEET #: 009-9037-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
3 of 4
Select slot in tray according to diagram 5.1.
Removebacking and attach oneclear strip (E)
throughslot and aroundedge of trayas pictured
in diagram 5.2. Repeat for other slot in other side
of tray.
Note:This materialprevents fraying or cuttingof
the belt.
Place electronic component onto tray.
Note: Be sure that front bottom edge of electronic
componentis positioned behindand against the
frontlip of the tray. This will prevent electronic
component fromsliding forward onthe tray.
Take one belt (C or D) and hold it so that the tri-bar belt clip (A) is facing as illustrated. Feed belt (C or D)
up through the slot you have chosen. Remember, belt only goes through outside slot. Now feed belt (C or
D) through belt clip (A) as shown. Repeat on other side of tray using other belt.
ELECTRONICCOMPONENT NOTSHOWN
C or D
ATIGHTEN
E
DIAGRAM
5.2
DIAGRAM
5.1 BELTSLOTS
TRAY
ELECTRONIC COMPONENT NOT SHOWN
FRONTLIP
electronic component
ELECTRONIC COMPONENT NOT SHOWN

ISSUED: 01-30-07 SHEET #: 009-9037-1
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
4 of 4
• The safety belt provided with your mount is designed to stabilize the electronic component on the mounting tray.
• It is the responsibility of the installer to ensure the stability of the television by purposefully pushing the electronic
component in all directions to test the installation.
WARNING
Tightenbelt by pulling on loose end.
LOOSEEND