EEM100
V. 01 –07/05/2015 5 ©Velleman nv
3. Replace the battery with a new 9 V battery.
4. Close the battery compartment.
Warning: Do not puncture batteries or throw them in fire as they
may explode. Do not attempt to recharge non
batteries (alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.
7. Operation
1. Aim the IR sensor [B] at the target and press the measurement
trigger [D] to display the target’s surface temperature. A red laser
spot appears on the target during measurement.
2. The distance-to-target ratio is 12:1. This means that, for example, at
12 cm, the target must be larger than 1 cm to get a proper
measurement. Make sure the target area is within this field of view.
3. The device can measure temperatures in °C or °F. Press the mode
key [F] while the device is on to switch between measurement units.
The corresponding symbol (°C or °F) appears on the display.
4. When you release the measurement trigger [D], the hold mode is
automatically activated: the last measurement value remains on the
display until you press the measurement key again, or until the device
shuts off automatically (after approx. 7 seconds).
5. Note that the display is always on, while the laser is only on during
measurement.
of a shiny or polished metal surface
·
through a transparent surface such as glass
·
of an object covered with frost, grime, oil
8. Cleaning and Maintenance
·The IR sensor [B] is the most delicate part of the device and it shall be
kept clean at all times. To do this, only use a soft cloth or cotton bud
with a little water or medical alcohol.
·Allow the lens to fully dry before using the device.
·Wipe the other parts of the device regularly with a moist, lint-free cloth.
Do not use alcohol or solvents.
·Do not submerge the device in water or any other liquid.
·There are no user-serviceable parts. Contact your dealer for spare parts
if necessary.
·The device shall be stored between –20° C and +65° C (–4° F to
+149° F).
