Pet Gear DESIGNER COT User manual

INSTRUCTION MANUAL
DESIGNER COT/LIFESTYLE COT
PG6230/PG6240/PG6250
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
For The ON-THE-GO Pet™

DESIGNER COT • PG6230/PG6240/PG6250
2
WARNING!
REPLACEMENT PARTS
INSTRUCTIONS
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw
aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive,
destructive, immature or untrained animals. Do not use near an open or exposed ame. Failure to follow these
warnings and the instructions could result in serious injury or death.
Remove cot from carton and remove plastic.
Pull side legs out on both sides of cot.
Then pull the middle support bar* down
to the center, as shown in Figure A.
*Our smaller model, the PG6230 does not have a middle support bar.
A.
Use only PET GEAR replacement parts.
Please have your model number ready before calling.
You can also request parts: http://www.petgearinc.com/main.asp?sel=2
192 Sheldon Avenue • West Rutland, VT 05777 • 877-752-9123 • www.petgearinc.com