Pet Gear The ON-THE-GO Pet I-GO2 PLUS TRAVELER User manual

INSTRUCTION
I-GO2 PLUS TRAVELER
PG1280
Carrier/Car Seat/Backpack/Roller Bag/Tote
For The ON-THE-GO Pet™

I-GO2 PLUS TRAVELER • PG1280
2
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
Carrying Strap
I-GO2 Plus Traveler
Tether and D-Ring.
(This has been sewn into the
interior of the unit.)
To attach carry strap, clip each end of the carry strap
to the two plastic rings, located near the top of the
I-GO2, shown in Figure A.
TO ATTACH CARRY STRAP
A.
Fleece-Top Comfort
Liner with Hook & Loop
Fasteners.

I-GO2 PLUS TRAVELER • PG1280 3
TO USE WHEEL COVER
TO USE AS CAR SEAT
To use wheel cover, unzip, pull out cover on the
back of the I-GO2, and cover wheels (shown in
Figure B).
Step 1. To use the Plus Traveler as a car seat, take
seatbelt and place it through the seatbelt straps and
buckle seatbelt to secure (shown in Figure C).
Step 2. Next attach carrying strap around headrest
and adjust to a secure position (shown in Figure D).
B.
C. D.

TO USE TELESCOPE HANDLE
E.
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw
aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive,
destructive, immature or untrained animals. Do not use near an open or exposed ame. Failure to follow these
warnings and the instructions could result in serious injury or death.
To use telescope handle, push top button on handle,
pull up until it clicks (shown in Figure E).
Discover other pet travel accessories on our website.