Pet Gear HOME'N GO PG4800MG User manual

INSTRUCTION MANUAL
HOME ‘N GO
Pet Pen without Bottom
PG4800MG
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
For The ON-THE-GO Pet™
For Pets
Only

HOME ‘N GO PET PEN PG4800MG
2
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig,
chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage
caused by aggressive, destructive, immature or untrained animals.
Do not use near an open or exposed
flame. Failure to follow these warnings and the instructions could result in serious injury or death.
Never use plastic shipping bags or other plastic film as pad covers not sold and intended for that
purpose. They can cause suffocation. This product is not intended for commercial use.
AVOIDING SUFFOCATION HAZARDS
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
Be sure the Pet Pen is completely set up before use.
Always follow the instructions in the product instructions to set up the Pet Pen.
Before each use, inspect this product for damaged hardware, loose joints, missing parts, or sharp edges.
Do not use the Pet Pen if any parts are missing or broken.
Call PET GEAR at 1-877-752-9123 for replacement parts. Use only PET GEAR replacement parts.
Visit our website www.petgearinc.com to view or download the product instructions.
Do not substitute parts.
SETTING UP THE PET PLAY AREA
Remove collar and leashes while using this product. The Pet Pen is for playing or sleeping.
When used for playing, never leave pet unattended and always keep pet in view. When used for
sleeping, you must still provide the supervision necessary for the continued safety of your pet.
Always keep the Pet Pen away from hazards in the area that may injure your pet.
DO NOT leave pet in product for prolonged periods of time.
USING THE PET PLAY AREA

PARTS LIST
SET UP
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service. No tools required.
3
HOME ‘N GO PET PEN PG4800MG
DO NOT push center down yet.
Step 1. When setting up, lock rails BEFORE lowering
secondary latch.
Step 2. Be sure top rails have become rigid. If not,
pull up again until they are rigid.
If top rails do not latch, push the button of the legs
toward each other.
Pen

SET UP
4HOME ‘N GO PET PEN PG4800MG
Step 3. Engage secondary latch by pushing tubes down to
the floor and turning secondary latch.
Repeat this so all four sides have the secondary lock
engaged.
TO FOLD
*If top rails do not unlatch,
DO NOT FORCE.
Push the bottom of the legs
toward each other.
*Both tubes must be released for
the top rail to fold.
Step 3. Do Not Force. If unit will not fold,
look for a partially latched top rail. Squeeze
the latch button to release the rail.
Step 1. DO NOT unlock top rails yet. Release secondary latch.
Lift up on tubes to create a “V” shape on all four sides.
Step 2. Secondary latch must be released and tubes pulled up to
create a “V” shape.
Lift up slightly on the top rail.
Push in on the button located on the side of the top rail to release
the two tubes.
Push down.

From time to time, check your Pet Play Area for worn parts, torn material or stitching.
To clean Pet Play Area, use only household soap or detergent and warm water.
5
CARE AND MAINTENANCE
HOME ‘N GO PET PEN PG4800MG
REPLACEMENT PARTS
Please have your model number ready before calling. Use only PET GEAR replacement parts.
PO Box 99
West Rutland, VT 05777
877-752-9123
www.petgearinc.com