Pet Gear PG8030 User manual

PET
GEAR
Inc.
West Rutland,VT 05777
877-752-9123
WWW.PETGEARINC.COM
®
N o t i n t e n d e d t o b e u s e d a s a
r e s t r a i n i n g d e v i c e f o r a g g r e s s i v e
o r d a n g e r o u s a n i m a l s t h a t d i g , c h e w
o r p a w a g g r e s s i v e l y . D o n o t l e a v e
y o u r p e t u n a t t e n d e d f o r l o n g p e r i o d s
o f t i m e . P E T G E A R i s n o t l i a b l e f o r
a n y d a m a g e c a u s e d b y a g g r e s s i v e ,
d e s t r u c t i v e , i m m a t u r e o r u n t r a i n e d
a n i m a l s . N o t s u i t a b l e f o r a i r l i n e t r a v e l .
TM
INSTRUCTION MANUAL
Ultra-Lite Pet Stroller PG8030
For Pets Only

TO OPEN STROLLER
Step 1. Release locking latch.
Step 2. Unfold as shown.
Make sure both locks
snap into place.
1
2TO ASSEMBLE FRONT WHEELS
Step 1. Turn stroller over as shown.
Step 2. Push wheel assembly
onto stroller leg until it snaps into place.
Step 3. Repeat for other wheel.
Tug firmly on each wheel assembly to
be sure wheels are securely in place.
NOTE: To remove, squeeze tab
and pull wheel off.
1.
Note: Direction of
Arrow

3TO ASSEMBLE REAR WHEELS
AXLE WASHER RETAINER CAP
Step 1. Remove and discard
protective sleeve from ends of rear
axle assembly and rear leg tubes.
Step 2. Position rear axle assemblies
onto rear leg tubes at the same time.
Step 3. Slide wheel onto axle.
Step 4. Slide washer onto axle.
Step 5. Fit straight part of cotter pin
through hole on axle.
Step 6. Line up each of the tabs in the
hub cup with the slots in the wheel. Snap
hub cap into place. Fit cover to collet by
firmly pressing the cover into place.
Step 7. Repeat for other side.
2.
COTTER PIN

TO OPERATE BRAKES
Step 1. Push levers on both rear wheels
down to lock.
Step 2. Pull levers up to unlock.
4
5TO FOLD STROLLER
1. Lock brakes.
2. Close canopy.
A. Standing behind stroller,
pull up on both side latches.
B. Fold as shown.
NOTE: fold stroller so wheels
straddle frame. DO NOT allow
wheels to press against frame as
this may damage tires.
3.
Before folding:
C. Engage locking latch.
UNLOCK
LOCK

4.
WHEEL MAINTENANCE
-To clean and lubricate front and rear wheels, push out locking lever under wheel housing
to release rear wheel.
-To ensure ease of maneuverability and to minimize wear and tear, keep all moving parts
clean and lubricated with WD40 or light machine oil.
-Push wheel sets back on until they click and lock in position. Pull on wheel housings to
ensure they are secure.
-Push stroller back and forth and rotate swivels around to work in lubricant.
-Clean the rear wheel assembly and the rest of the frame with warm soapy water;
clean off with warm water and dry thoroughly.
NOTE: Do not lubricate brake components.
WARNING
-For pets only.
-Do not carry additional bags, goods, or accessories in or on stroller except as
recommended in the manufacturer’s instructions.
-Do not leave pet unsupervised in stroller.
-Before making adjustments to stroller ensure that pet’s body is clear of any
moving parts.
-This stroller is designed for one pet only.
-Do not hang bags from handles as this may cause product to become unstable.
-Do not use on escalator or stairs. Fold stroller and carry.
-Put on brake whenever you park the stroller.
-Ensure stroller is completely erected and check all locks are engaged before
placing pet in stroller.
-Do not overload as stroller may become unstable. Maximum weight of pet using
this stroller should not exceed 20 lbs.
-Do not use near an open or exposed flame.