Pet Gear PG8500 User manual

INSTRUCTION MANUAL
TRAVEL SYSTEM
Pet Stroller
PG8500
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
For The ON-THE-GO Pet™
For Pets
Only
Interior Dimensions:
19L x 11W x 11H

TRAVEL SYSTEM Pet Stroller PG8500
2
• Do not carry additional bags, goods, or accessories in or on stroller except as recommended
in the manufacturer’s instructions.
• Recommended use of an approved safety restraint correctly fitted and adjusted.
• Do not leave pet unsupervised in stroller.
• Before making adjustments to stroller ensure that pet’s body is clear of any moving parts.
• This stroller is designed for one pet only.
• Do not hang bags from handles as this may cause the product to become unstable.
• Do not use on escalator or stairs; fold stroller and carry.
• Put on brake whenever you park the stroller.
• Ensure stroller is completely erected and check that all locks are engaged before placing
pet in stroller.
• Do not overload as stroller may become unstable; maximum weight of pet using this stroller
not to exceed 15 lbs.
• Any goods carried in the basket not to exceed 6 lbs.
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig,
chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage
caused by aggressive, destructive, immature or untrained animals.
Do not use near an open or exposed
flame. Failure to follow these warnings and the instructions could result in serious injury or death.
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
Carrier
Front Wheel
Assembly (2)
Back
Wheels (2) Rear Axle Assembly
Washer (2) Cotter Pin (2) Hub Cap (2)
Stroller

3
TO OPEN STROLLER
Step 1. Release locking latch.
Step 2. Unfold as shown. Make sure both
locks snap into place.
TO ASSEMBLE FRONT WHEELS
Note Direction
of Arrow
Step 1. Turn stroller over as shown.
Step 2. Push wheel assembly onto stroller
leg until it snaps into place. Tug firmly on
wheel assembly to be sure that wheel is
securely in place. Repeat for other wheel.
NOTE: To remove,
squeeze tab and
pull wheel off.
TRAVEL SYSTEM Pet Stroller PG8500

4TRAVEL SYSTEM Pet Stroller PG8500
TO ASSEMBLE REAR WHEELS
Step 1. Remove and discard protective sleeve
from ends of rear axle assembly and rear leg tubes.
Step 2. Position rear axle assemblies onto rear leg
tubes at the same time.
Step 3. Slide wheel onto axle.
Step 4. Slide washer onto axle.
Step 5. Fit straight part of cotter pin through hole
on axle.
Step 6. Line up each of the tabs in the hub cap
with the slots in the wheel. Snap hub cap into place.
Fit cover to collet by firmly pressing the cover into
place.
Step 7. Repeat for other side.
TO ATTACH CARRIER TO FRAME
Attach Carrier with Velcro-2 places on each side.

TO USE IN VEHICLE
5
TRAVEL SYSTEM Pet Stroller PG8500
TO OPERATE BRAKES
UNLOCK
LOCK
Step 1. Push levers on both rear wheels down to lock.
Step 2. Pull levers up to unlock.
Place seat belt through strap and adjust seat belt.

TO FOLD STROLLER
6
Step 1. Before folding, Lock brakes and
close canopy.
Step 2. Standing behind stroller, pull up on
both side latches.
Step 3. Fold as shown.
NOTE: Fold stroller so wheels
straddle frame. DO NOT allow
wheels to press against frame
as this may damage tires.
Step 4. Engage locking latch.
TRAVEL SYSTEM Pet Stroller PG8500

7
TRAVEL SYSTEM Pet Stroller PG8500
For Pets
Up To
15 lbs
•Always store product in a clean, dry place.
• Not recommended for use on the beach.
• Do not put heavy items on top of the stroller.
•Clean frame by wiping with a lightly oiled cloth.
• Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap and warm water.
•To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles, and swivels),
keep all moving parts clean and lubricated with WD40® or light machine oil.
• NOTE: Do not lubricate brake components or swivel locks.
• Regularly check stroller for loose parts. These should be tightened or replaced.
LOOKING AFTER YOUR STROLLER
•To clean and lubricate front and rear wheels, push out locking lever under wheel housing
to release rear wheel.
•To ensure ease of maneuverability and to minimize wear and tear, keep all moving parts
clean and lubricated with WD40® or light machine oil.
•Push wheel sets back on until they click and lock in position; pull on wheel housings to
ensure they are secure.
•Push stroller back and forth and rotate swivels around to work in lubricant.
•Clean the rear wheel assembly and the rest of the frame with warm, soapy water; clean
off with warm water and dry thoroughly.
•NOTE: Do not lubricate brake components or swivel locks.
WHEEL MAINTENANCE
PO Box 99
West Rutland, VT 05777
877-752-9123
www.petgearinc.com
REPLACEMENT PARTS
Please have your model number ready before calling. Use only PET GEAR replacement parts.