Pet Gear I-GO2 Traveler User manual

INSTRUCTION MANUAL
I-GO2 Traveler
PG1240
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
Carrier/Car Seat/Backpack/Roller Bag/Tote
For Pets
Only
For The ON-THE-GO Pet™

I-GO2 Traveler PG1240
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service. No tools required.
Tether and D-Ring. (This has been sewn
into the interior of the unit.)
Reinforcement Board
Fleece-Top Comfort Liner with
Hook & Loop Fasteners
For Pets
Up To
20 lbs
2
I-GO2 Traveler
Carrying Strap

INSTRUCTIONS
I-GO2 Traveler PG1240 3
Step 1. Remove I-GO2 from
carton. Unzip side zippers to
expand the width of the Traveler.
This will allow you to put install
the Reinforcement Board.
Step 2. Fold Reinforcement
Board as shown in Figure A.
Step 3. Place Reinforcement Board inside the
Traveler at an angle, as shown in Figures B and C.
Unzip side zippers.
Figure A
Shown unzipped.
Reinforcement Board shown flat.
Figure C
Figure B
Figure D
Step 4. Lift up the hook & loop fastener
strips so they are above the Reinforcement
Board as shown in Figure D. You will need
the hook & loop fastener strips to attach
Fleece-Top Comfort Liner. See Step 6.

INSTRUCTIONS
I-GO2 Traveler PG1240
4
Step 6. Place Fleece-Top Comfort
Liner inside the I-GO2 and fasten into
place, using the two hook & loop
fastener strips.
See Figure F.
Figure E
Figure F
TO ATTACH CARRYING STRAP
To attach carrying strap, clip each end of the carrying
strap to the two plastic rings, located near the top of
the I-GO2, shown in Figure G.
Figure G
Step 5. Push down on the Reinforce-
ment Board until it lays flat inside of the
I-GO2, as shown in Figure E.

I-GO2 Traveler PG1240 5
TO USE WHEEL COVER
Figure H
To use wheel cover, unzip, pull out cover on the
back of the I-GO2, and cover wheels (shown in
Figure H).
TO USE AS A CAR SEAT
Step 1. To use the Traveler as a car seat, take
seatbelt and place it through the seatbelt straps
and buckle seatbelt to secure (shown in Figure J).
Step 2. Next attach carrying strap around head-
rest and adjust to a secure position (shown in
Figure K).
Figure J
Figure K

I-GO2 Traveler PG1240 5
TO USE WHEEL COVER
Figure H
To use wheel cover, unzip, pull out cover on the
back of the I-GO2, and cover wheels (shown in
Figure H).
TO USE AS A CAR SEAT
Step 1. To use the Traveler as a car seat, take
seatbelt and place it through the seatbelt straps
and buckle seatbelt to secure (shown in Figure J).
Step 2. Next attach carrying strap around head-
rest and adjust to a secure position (shown in
Figure K).
Figure J
Figure K

6I-GO2 Traveler PG1240
TO USE TELESCOPE HANDLE
To use telescope handle, push top button on
handle, pull up until it clicks (shown in Figure L). Figure L
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig,
chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage
caused by aggressive, destructive, immature or untrained animals.
Do not use near an open or exposed
flame. Failure to follow these warnings and the instructions could result in serious injury or death.
REPLACEMENT PARTS
Please have your model number ready before calling. Use only PET GEAR replacement parts.
PO Box 99
West Rutland, VT 05777
877-752-9123
www.petgearinc.com