Pet Gear ROADSTER PG8600 User manual

INSTRUCTION MANUAL
Roadster Pet Stroller
PG8600
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
For The ON-THE-GO Pet™
For Pets
Only

•For pets only.
•Do not carry additional bags, goods, or accessories in or on stroller except as recommended
in the manufacturer’s instructions.
•Recommended use of an approved safety restraint correctly fitted and adjusted.
•Do not leave pet unsupervised in stroller.
•Before making adjustments to stroller ensure that pet’s body is clear of any moving parts.
•This stroller is designed for one pet only.
•Do not hang bags from handles as this may cause the product to become unstable.
•Do not use on escalator or stairs; fold stroller and carry.
•Put on brake whenever you park the stroller.
•Ensure stroller is completely erected and check that all locks are engaged before placing pet
in stroller.
•Do not overload as stroller may become unstable; maximum weight of pet using this stroller
should not exceed 100 lbs.
•Do not use near an open or exposed flame.
•To clean and lubricate rear wheels, push center pin in to release rear wheels from axle.
•To ensure ease of maneuverability and to minimize wear and tear, keep all moving parts
clean and lubricated with WD40®or light machine oil.
•Push wheel sets back on until they click and lock in position; pull on wheel housings to
ensure they are secure.
•Push stroller back and forth and rotate swivels around to work in lubricant.
•Clean the rear wheel assembly and the rest of the frame with warm, soapy water;
clean off with warm water and dry thoroughly.
NOTE: Do not lubricate brake components.
WARNING!
WHEEL MAINTENANCE
2
PARTS LIST
Axle Roadster Stroller PG8600
Front Wheel Rear
Wheels
Stroller

3
ASSEMBLY INSTRUCTIONS
Roadster Stroller PG8600
1. Slide back wheel on axle as
shown in Figure B. Push in axel until
it clicks. Pull on wheel to make sure
the wheel is engaged. Repeat on
other side. When finished it should
look like Figure C.
Note: To remove wheel, push the lock/release button
and pull wheel off.
Inside
Lock/Release Button
Outside
Back Wheels
Figure B
Figure A
Figure C

Roadster Stroller PG8600
ASSEMBLY INSTRUCTIONS
2. Take rear wheels (on axel with brakes)
and lock them into the 2" posts by placing
leg tube over the posts and pressing down
until they click (shown in Figure D). Pull
up to make sure wheels are locked.
3. Place stroller so wheels are on the ground
and back wheels are facing you (shown in
Figure E).
Note: To remove back wheels, push the
lock/release button and pull wheel off.
Figure D
4. Lift right and left side of stroller up.
Shown in Figure F. Secure the support bar
that goes from the left and latches down
on the right side (shown in Figure F).
Figure E
Figure F
5. To install the handle, place handle ends into
the handle-locking mechanisms on each side of
the stroller. Then, push down until you hear a
click and the velco buttons pop out on each
side. From here, you can choose desired height
level (1 or 2). Pull up on handle to make sure it
is securely locked. This is shown in Figure G.
Handle-Locking Mechanisms
4
Figure G

5
7. Slide wheel up, until velco pins pop out
of holes.
Velco Pin
Velco Pin
Tubing Tubing
8. To use stroller in locked position for
jogging, push pin in. 9. To use stroller in swivel position, pull
pin down, and to the right.
ASSEMBLY INSTRUCTIONS
Swivel
Position
Roadster Stroller PG8600
Locked Position
6. To attach front wheel, slide plastic
wheel support up and into tubing.

•Front wheel fixed and swivels
•Folds flat for storage
•Quick-release EVA tires
•Front and top entry
•Extra wide for pets up to 100 lbs.
•Rear safety brakes
•Top, front, and side mesh windows for ventilation
•Ergonomic handle
•Large wheels for easy mobility
•Interior dimensions 33"L x 20"W x 21"H (83cm x 50cm x 53cm)
•Always store product in a clean, dry place.
•Not recommended for use on the beach.
•Do not put heavy items on top of the stroller.
•Clean frame by wiping with a lightly oiled cloth.
•Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap and warm water.
•To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles,
and swivels), keep all moving parts clean and lubricated with WD40®or light machine oil.
•NOTE: Do not lubricate brake components or swivel locks.
•Regularly check stroller for loose parts. These should be tightened or replaced.
PO Box 99
West Rutland, VT 05777
877-752-9123
WWW.PETGEARINC.COM
FEATURES
LOOKING AFTER YOUR STROLLER
6Roadster Stroller PG8600