Philips AVENT SCF255/60 User manual

GB
TC

=
=
a
b
c
2
3
1

outlined
non-outlined >>>>
non-outlined
TEMPERATURE OF FEED BEFORE WARMING*
5ºC
(40ºF)
20ºC
(70ºF)
5 mins†4 mins
7 mins 5 mins
8.5 mins 6 mins
5 mins
7 mins
4.5 mins
5.5 mins
130g
125ml
260ml
330ml
4oz
9oz
11oz
190g
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
3

Please take 5 minutes to read through the whole
of this leaflet before you use your Electric Bottle
and Baby Food Warmer for the first time and
retain for future reference.
The Electric Bottle and Baby Food Warmer allows you
to warm all AVENT Feeding Bottles as well as baby
food jars and tins safely and quickly. The Electric Bottle
and Baby Food Warmer isn’t meant for keeping liquid
or food warm as vitamins can be destroyed.
The speed at which the warmer heats the milk or
food depends on the size of the bottle or container
and the starting temperature of the milk or food
(e.g. room temperature 20°C or out of fridge 5°C).
Diagram 2 gives an indication of approximate
warming time. Always test the temperature before
feeding.
The following guidelines are the approximate
temperature the water* surrounding the
container can reach. This is not a heating guide
for liquid or food!
Contents
a) Basket
b) Warmer body
c) Dial
Instructions for Use
For AVENT Feeding Bottles
1) Ensure basket is in place inside the warmer.
2) Place the assembled, filled bottle in the warmer.
3) For 125ml/4oz Bottles, fill the warmer with water
to just above the level of milk in the bottle.
4) For larger AVENT Bottles (260ml/9oz), fill the
warmer to 15mm (1/2 inch) below the rim of
the warmer.
5) Never let the water level rise above the neck of
the bottle or spill over the edge of the warmer.
6) Plug the unit into an electrical outlet and click the
switch to the ON position (I).
Turn the dial to setting 3.
7) The light will illuminate to indicate the warmer
is working.
8) During the warming process, the light will come
on and off to indicate that the water surrounding
the bottle is being heated to the maximum
temperature of the setting.
9) Always test the feed and when it has reached
the required temperature, remove immediately.
10) Shake the bottle gently and check the temperature
of the milk by sprinkling a few drops on to your
wrist before you feed your baby.
11) Take care not to overheat the milk.
NB: please refer to the timings in Diagram 2.
NB: The basket can be removed when heating the
AVENT Magic Cup and other makes of bottles.
For baby food jars and tins
1) Ensure basket is in place inside the warmer.
2) Remove the lid and place jar or tin in the warmer.
3) Fill the warmer with water to 15mm (1/2 inch)
below the top of the jar/tin.
4) Plug the unit into an electrical outlet and click the
switch to the ON position (I).
Turn the dial to setting 3.
5) Continue as 7-9 above.
6) The warmer will work in the same way as for
feeding bottles. Take care when removing the jar
or tin as they, and the water surrounding them,
will be hot.
7) For small jars/tins you may find it beneficial
to place a screw ring from an AVENT
Bottle below the jar/tin before adding the
water in order to remove the container easily.
8) Stir the food and test it on a spoon yourself
to ensure it is not too hot for your baby.
9) Take care not to overheat the feed.
NB: please refer to the timings in Diagram 2.
Care of your warmer
Switch off (O), unplug and allow to cool before
cleaning. Remove basket and wipe inside and outside
with a damp cloth only, this will keep the warmer
looking new. DO NOT USE AN ABRASIVE CLEANER.
It may be advantageous to use pre-boiled or filtered
water in your warmer in order to reduce limescale
build up.
De-scaling
You should de-scale your Electric Bottle and Baby Food
Warmer every four weeks to ensure it continues to
work 100 % effectively.
Philips AVENT Electric Bottle and Baby Food Warmer
4
Setting Approximate water* temperature
surrounding the container
1 35 – 45 °C
2 45 – 75 °C
3 75 – 85 °C
GB

EITHER:
Mix one sachet of citric acid (10g) with 200ml/7oz
of water. Ensure basket is in place and pour solution
into warmer. Heat for 10 minutes on setting 3. After
10 minutes, switch off by unplugging from the wall
and leave to stand for 30 minutes. Pour the solution
away and rinse the warmer with tap water. Citric acid
is available from most chemists and through Philips
AVENT Customer Service.
OR
Pour 50ml/2oz of vinegar (white) mixed with
100ml/4oz of cold water into the warmer (with
basket in place). Allow to stand in the unit until
any limescale has dissolved. Empty the unit and
rinse thoroughly.
Warning!
The Electric Bottle and Baby Food Warmer is fitted
with a non-rewireable moulded plug. The mains
supply cord of the appliance CANNOT be replaced.
If the cord is damaged, the appliance should
be discarded.
The lead supplied must not be used on any other
appliance and no other lead should be used with the
Electric Bottle and Baby Food Warmer.
This product is manufactured to comply with
the Radio Interference Requirements and the
EEC Directive 89/336/EEC.
• Wheninusethewarmercontainshotwater.
• Alwaysplacecontainerintowarmerbefore
adding water.
• Ensurewaterhasbeenaddedbefore
switching the unit on.
• Ifthefeedisleftinthewarmer,thetemperature
will continue to increase as the thermostat cuts
in/out whilst connected to the electric mains.
• Alwaystestthetemperaturebeforefeeding.Once
the food has reached the correct temperature and
has been removed from the unit, switch off (O) and
unplug from the electrical outlet.
• NEVER IMMERSE IN WATER.
• Thisapplianceisintendedforusebyresponsible
persons, keep out of the reach of small children
and the infirm.
• Thisapplianceisnotintendedforusebypersons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
or knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Childrenshouldbesupervisedtoensurethatthey
do not play with the appliance.
For your child’s safety and health Warning!
Before first use, clean the product. Dishwasher safe.
Sterilise using a Philips AVENT Steam Steriliser or boil
for 5 minutes. Before each use, inspect the product.
Throw away at the first sign of damage or weakness.
Do not leave in sunlight when not in use or for longer
than recommended in heat or sterilising solution,
as this may weaken the product. Always use this
product with adult supervision. Always check food
temperature before feeding.
Guarantee
Philips AVENT guarantees that should the Electric
Bottle and Baby Food Warmer become faulty during
24 months from the date of purchase, it will be
replaced free of charge during this time. Please return
it to the retailer where it was purchased. Please keep
your receipt as a proof of purchase, together with a
note of when and where purchased. For the guarantee
to be valid, please note:
• TheElectricBottleandBabyFoodWarmermust
be used according to the instructions in this leaflet
and connected to a suitable electricity supply.
• Theclaimmustnotbearesultofaccident,
misuse, dirt, neglect or fair wear and tear.
This does not affect your statutory rights.
Philips AVENT is here to help
GB: Call FREE on 0800 289 064
IRL: Call FREE on 1800 509 021
AU: 1 300 364 474
www.philips.com/AVENT
5
GB

6
TC

7
TC

Trademarks owned by the Philips Group.
© Koninklijke Philips Electronics N.V. All Rights Reserved.
www.philips.com/AVENT
Philips AVENT, a business of Philips Electronics UK Ltd.
Philips Centre, Guildford Business Park, Guildford, Surrey, GU2 8XH
GB Call FREE on 0800 289 064
[phone] / 0800-231-099
TC
42133 5435 550 (09/09)