Philips HX6733/80 User manual

Quick start guide
Review IMPORTANT SAFEGUARD section of your
user manual prior to the rst use.
Contents: Before
you start
HealthyWhite brushing modes and brush heads:
Your Sonicare HealthyWhite is set to Clean mode. Push the on/off button to toggle between modes.
A green LED indicates the selected mode.
Modes:
Clean mode: Standard mode for complete cleaning.
Sensitive mode: Gentle, yet thorough cleaning for sensitive gums and teeth.
Clean and White mode: 2 minutes of Clean mode with an additional 30 seconds of White mode to focus on
your visible front teeth.
Brush heads:
ProResults brush head: Fits the natural shape of your teeth for a thorough clean.
HydroClean brush head: HydroGuides push uid between teeth for a oss-like clean.*
*Does not replace ossing
Charge for 2 hours
minimum
1
clean
sensitive
Clean
and
White
On/Off
Modes
HydroClean
brush head
Travel charger UV sanitizer / charger Sonicare toothbrushes
with ProResults brush heads
clean
sensitive
Clean
and
White
clean
sensitive
Clean
and
White
clean
sensitive
Clean
and
White
Travel case

Brushing instructions:
4235 020 45661
UV Sanitizer:
Before turning your Sonicare on, wet the bristles and apply a small amount of toothpaste.
Place bristles against your teeth at a slight angle towards the gumline.
Hold the handle with a light grip and gently move the brush head slowly across the teeth in
a small back and forth motion so the longer bristles reach between your teeth. Continue this
motion throughout your brushing cycle.
You may experience a slight tickling/tingling sensation when using your Sonicare toothbrush for
the rst time. As you become accustomed to brushing with Sonicare, this sensation will diminish.
The UV sanitizer uses a specially designed UV light bulb to eliminate
germs on your brush head.
After brushing, rinse the brush head and shake off excess water.
Place the brush head/s on the peg/s located inside the UV sanitizer.
Make sure bristles face the UV light bulb. Do not place the travel cap
on the brush head during sanitization.
Close the door and press the green power on/off button once to
select the UV clean cycle.
The UV clean LED light will blink during sanitization.
UV clean LED light will turn a solid green and the sanitizer will
automatically shut off when the sanitizing cycle is complete.
2
3