Philips Sonicare Elite HX5910/71 User manual

Quick start guide
Review IMPORTANT SAFEGUARD section of your
user manual prior to the first use.
Contents:
Before
you start
Elite brushing modes and brush heads:
Your Sonicare Elite has two brushing modes. Press the on/off button once to activate the "Clean" mode.
Press it a second time to switch to the "Massage" mode.
Modes:
Clean mode:Standard mode for superior teeth cleaning.
Massage mode: Mode for gentle gum stimulation.
Quadpacer:
Encourages attentive brushing of each quadrant of the mouth and reinforces a recommended brushing time of at least 2 minutes.
Brush heads:
Unique slim, angled neck and contour-fit bristles for greater plaque removal in those hard-to-reach areas.
Charge for 2 hours
minimum
2 Sonicare Elite handles
2 Chargers
3 Standard brush heads
2 Travel cases
2 Brush head holders
1
Questions? Call Philips Consumer Care at 1-800-682-7664
Trim 5” x7”
C
M
Y
CM
MY
CY
CMY
K
ELITE_clubQSG_P1.pdf 1 12/20/11 9:59 AM

Brushing instructions:
4235 020 53261
Easy-start brushing power ramp-up
Before turning your Sonicare on, wet the bristlesand apply a small amount oftoothpaste.
Place bristlesagainst your teeth at a slight angletowards the gumline.
Hold the handle witha light grip and gently move the brush head slowly acrossthe teethin
a small back and forth motionso the longerbristles reachbetween your teeth. Continue this
motionthroughout your brushing cycle.
You may experience a slight tickling/tingling sensation when using your Sonicare toothbrush for
the first time.As you become accustomed to brushing with Sonicare, this sensation will diminish.
2
3
All Sonicare models come with the Easy-start feature activated (on), which helps you get used to brushing with Sonicare and brushing
power will gently increase to full power over the first 12 brushings. The Easy-start feature is active if you hear 2 beeps immediately after
turning on your Sonicare. Once you reach optimal brushing power (after the 12th brushing), you will no longer hear the double beep at
the beginning of your brushing routine.
Note: Each of the first 12 brushings must be at least 1 minute in length to properly move through the Easy-start ramp-up cycle.
To deactivate or activate the Easy-start feature:
1. Attach your brush head to the handle.
2. Place the handle in a plugged-in charger base.
3. To deactivate the Easy-start feature, press and hold the power button for 5 seconds. You will hear 1 beep to
indicate that the Easy-start feature has been deactivated.
4. To activate the Easy-start feature, press and hold the power button for 5 seconds. You will hear 2 beeps to indicate that the Easy-start
feature has been activated.
Trim 5” x7”
C
M
Y
CM
MY
CY
CMY
K
CC_clubQSG_P2.pdf 1 12/12/11 11:38 AM