Philips Sonicare HX6284/64 User manual

Sonicare
toothbrush
for teens

1
2
3
4
5
6
1

English 6
简体中文 15
繁體中文 24

English
Introduction
Congratulations on your purchase and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
Important safety information
Read this important information carefully before you use the device
and save it for future reference.
Danger
- Keep the charger away from water. Do not place or store it over or
near water contained in a bathtub, washbasin, sink etc. Do not
immerse the charger in water or any other liquid. After cleaning,
make sure the charger is completely dry before you connect it to
the mains.
Warning
- The mains cord cannot be replaced. If the mains cord is damaged,
discard the charger.
- Always have the charger replaced with one of the original type in
order to avoid a hazard.
- Do not use the charger outdoors or near heated surfaces.
- If the appliance is damaged in any way (brush head, toothbrush
handle or charger), stop using it. This appliance contains no
serviceable parts. If the appliance is damaged, contact the
Consumer Care Centre in your country (see chapter ‘Guarantee
and support').
- This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
Caution
- Do not clean the brush head, the handle or the charger in the
dishwasher.
6English

- If you have had oral or gum surgery in the previous 2 months,
consult your dentist before you use the toothbrush.
- Consult your dentist if excessive bleeding occurs after using this
toothbrush or if bleeding continues to occur after 1 week of use.
Also consult your dentist if you experience discomfort or pain
when you use the Philips Sonicare.
- The Philips Sonicare toothbrush complies with the safety
standards for electromagnetic devices. If you have a pacemaker or
other implanted device, contact your physician or the device
manufacturer of the implanted device prior to use.
- If you have medical concerns, consult your doctor before you use
the Philips Sonicare.
- This appliance has only been designed for cleaning teeth, gums
and tongue. Do not use it for any other purpose. Stop using the
appliance and contact your doctor if you experience any
discomfort or pain.
- The Philips Sonicare toothbrush is a personal care device and is
not intended for use on multiple patients in a dental practice or
institution.
- Stop using a brush head with crushed or bent bristles. Replace the
brush head every 3 months or sooner if signs of wear appear. Do
not use other brush heads than the ones recommended by the
manufacturer.
- If your toothpaste contains peroxide, baking soda or bicarbonate
(common in whitening toothpastes), thoroughly clean the brush
head with soap and water after each use. This prevents possible
cracking of the plastic.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
General description (Fig. 1)
1Hygienic travel cap
2Brush head with unique identifier
3Handle
4Power on/off button
5Battery level indicator
7
English

6Charger
- Not shown: Travel case
Note: The content of the box may vary based on the model
purchased.
Note: Brush head type may vary based on the model purchased
(different appearance as the picture shown here)
Preparing for use
Attaching the brush head
1Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 2).
2Firmly press the brush head down onto the metal shaft until it
stops.
Note: Philips Sonicare brush heads are imprinted with icons to easily
identify your brush head (Fig. 3).
Charging the appliance
1Plug the charger into an electrical outlet.
2Place the handle on the charger (Fig. 4).
- The battery level indicator flashes to indicate that the toothbrush
is charging. When the light stops flashing and turns solid green the
toothbrush is fully charged. (Fig. 5)
Note: It can take up to 48 hours to fully charge the battery, but the
Philips Sonicare may be used before it is fully charged.
Using the appliance
Brushing instructions
1Press the brush head onto the handle aligning the brush head. The
bristles will face the front of the handle. (Fig. 2)
2Rinse your mouth with water and vigorously swish away any
particles.
3Wet the bristles and apply a small amount of toothpaste.
4Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline. (Fig. 6)
8English

Keep the center of the brush in contact with the teeth at all times.
5Press the power on/off and mode button to turn on the Philips
Sonicare. (Fig. 7)
6Apply light pressure to maximize Philips Sonicare's effectiveness.
Brush your teeth with small back and forth motion so the bristles
reach between the teeth. (Fig. 8)
Note: The bristles should slightly flare. Do not scrub.
7While brushing, position the toothbrush bristles above and below
the wires and brackets. Use a circular motion to insure that the
inside of the brackets is thoroughly cleaned. (Fig. 9)
8To clean the inside surfaces of the front teeth, tilt the brush handle
semi-upright and make several vertical overlapping brushing
strokes on each tooth. (Fig. 10)
9To make sure you brush evenly throughout the mouth, divide the
mouth into 4 sections using the Quadpacer feature. The
quadpacer feature beeps after 30 seconds. (Fig. 11)
10 Brush for the full 2 minutes following the Quadpacer (Fig. 12). After
2 minutes, the toothbrush will automatically shut off.
11 After you have completed the brushing cycle, you can spend
additional time brushing the chewing surfaces of your teeth and
areas where staining occurs. (Fig. 13)
Your Philips Sonicare toothbrush is safe to use on:
- Braces (brush heads wear out sooner when used on braces)
- Dental restorations (fillings, crowns, veneers)
Note: Ensure that braces or dental restorations are properly adhered
and not compromised. If not, braces or dental restorations may be
damaged when they come into contact with the brush head.
Note: When the Philips Sonicare toothbrush is used in clinical studies,
the handle should be fully charged and the Easy-start feature
deactivated; brushing instructions will focus 2 minute brushing on
facial (outer) and lingual (inner) surfaces only. Extra time may be
added on to brush the chewing surfaces.
Battery status (when handle is not on charger)
- A yellow battery level indicator indicates a low charge.
9
English

- A green battery level indicator indicates a high charge.
- The battery level indicator turns off when the battery is in between
a low and a high charge.
Note:When you hear 3 beeps and the yellow LED of the battery level
indicator flashes, this means the battery charge is below 10% and the
toothbrush should be recharged.
Note:To keep the battery fully charged at all times, you may keep the
Sonicare on the charger when not in use.
Features
Quadpacer
- The Quadpacer is an interval timer that has a short beep and
pause to remind you to brush the 4 sections of your mouth evenly
and thoroughly. (Fig. 14)
Smartimer
The Smartimer indicates that your brushing cycle is complete by
automatically turning off the toothbrush at the end of the brushing
cycle.
Dental professionals recommend brushing no less than 2 minutes
twice a day.
Note: If you press the power on/off button after you started the
brushing cycle, the toothbrush will pause. After a pause of 30
seconds, the Smartimer resets.
Easy-start
The Easy-start feature gently increases power over the first 14
brushings to help you get used to brushing with the Philips Sonicare
toothbrush. This Philips Sonicare toothbrush comes with the Easy-
start feature activated.
Activating or deactivating the Easy-start feature:
Place the handle in the plugged-in charger.
- To activate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 2
beeps and the battery level indicator lights up green to indicate
that the Easy-start feature has been activated.
10 English