HX6311, HX6341, HX6381,
HX6330(handle)
4235-057-56091 _ 11_01_30
(YY_MM_DD) 2-4
Reapplying a panel that has been removed
Rinse the panel in warm water; you may also use a mild
detergent to clean it.
Let the panel air dry.
Reapply the panel to the white section on the front of the handle
Cleaning
Do not place brush head, the handle or the charger in the
dishwasher.
Rinse the brush head and bristles after each use and allow to air
dry completely.
Remove the brush head at least once a week and clean the
connection between the brush head and the handle and allow to
air dry completely. Do not use sharp objects to press on the
rubber seal at the top of the handle as this may cause damage.
Clean the rest of the handle periodically with mild soap and a
moist cloth.
Unplug the charger before cleaning and use a moist cloth to
wipe the surface of the charger.
If your toothpaste contains peroxide, baking soda or other
bicarbonate(common in whitening toothpastes), thoroughly
clean the brush head and the handle with soap and water after
each use. Otherwise the plastic may crack.
SAFETY INFORMATION
- Consult your physician prior to using Sonicare if you have
medical concerns.
- Contact your dental professional if excessive bleeding occurs
after using this product or bleeding continues to occur after 1
week of use.
- Sonicare has been tested and is compliant with safety standards
for electromagnetic devices.
- Do not place or store the charger where it can fall or be pulled
into a bathtub, sink or toilet.
- Children should be supervised to ensure that they do not play
with the appliance.
- Discontinue use if this product appears damaged in any way
(brush head, handle, charger).
TECHNICAL INFORMATION
Toothbrush Handle
- Voltage : 4.05 Volts d.c. at full charge
- Power consumption : 2 watts
- Charging time : Empty-to-full: 24 hours
- Operating time : Full-to-empty: 48 minutes
- Battery type : Lithium Ion
Travel Charger
- Voltage / Frequency : 100-240V, 50 - 60 Hz
- Power consumption : 0.4 watts @ 100V / 1.4 watts @ 240V
REPAIR INSTRUCTION
-Brush head (pos 2) In case of a defective brush head, the
complete brush head must be replaced.
-Charging unit (pos 1) In case of a defective charging unit or
cordset, the complete charging unit must be replaced.
-Handle toothbrush
The batteries inside cannot be replaced. In case of a defect, the
complete unit must be replaced.
-Charging the handle
It takes at least 24 hours to fully charge the handle battery.
ENVIRONMENT
-The rechargeable battery inside your Sonicare cannot be
replaced, but is easy to remove for recycling.
-The built-in rechargeable battery contains substances that may
pollute the environment. Always remove the battery before you
discard the appliance, and recycle or dispose of the battery
according to local waste management requirements.
-If you have any recycling questions, contact your local waste
management office.
Removing the rechargeable battery
To remove the rechargeable battery, you need a flat-head
(standard)screwdriver. Observe basic safety precautions
when you follow the procedure outlined below. Be sure to
protect your eyes, hands, fingers, and the surface on which
you work.
1. To deplete the rechargeable battery of any charge,
remove the handle from the charger, turn on the Sonicare
and let it run until it stops. Repeat this step until you can
no longer switch on the Sonicare.
6. The rechargeable battery can now be recycled and the rest
of the product discarded appropriately.
4. Hold the handle upside down
and push down on the shaft
to release the internal
components of the handle.
2. Insert a screwdriver into the
slot located at the bottom of
the handle and turn
counterclockwise until you
see a gap between cap and
handle.
5. Insert the screwdriver under
the circuit board, next to the
battery connections, and twist to
break the connections. Remove the
circuit board and pry the battery
from the
lastic carrier.
3. Insert the screwdriver into
the gap and pry the bottom
cap out of the handle.
