Philips Sonicare Sensiflex HX1610 User manual

ServiceManual
Philips Domestic Appliances and Personal Care
Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification
Electrical Tooth Brush
HX1610
07/09
PRODUCT INFORMATION
- Active tip : Removes plaque between the
teeth
- Number of brush heads
included in fancy box : 1
- Colours : White/ light blue
- Waterproof : Yes
- Anti rolling strip : To prevent the appliance
from rolling away
Safety information
- This product meets the requirements regarding
interference suppression on radio and TV.
- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.
TECHNICAL INFORMATION
- Voltage : 110 - 127 V, 200 - 240 V, 50 - 60Hz
- Power consumption : 2.8 Watts
- Speed (top) : Up to 15,000 brush strokes per
minute
- Charging time : Empty to full : 16 hours
- Operating time : Full to empty : ± 25 minutes
- Battery type : NiCd
Charging tips
- The appliance will only charge if the appliance is switched
off.
- Please note that the electricity supply to sockets in mirror
cabinets over washbasins or shaver sockets in bathrooms
may be cut off when the light is switched off.
- The toothbrush can be put back in the stand after use and
left to charge continuously. However, to extend the lifetime
of the battery proceed as follows:
When the appliance is used for the first time, continue to
use it until the battery is empty.
Use the appliance in the normal way without recharging it
between the brushing sessions.
Recharge the appliance when the motor almost stops
running.
Repeat this procedure 3 times in a row every 6 months.

HX1610
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- No specific issues
REPAIR INSTRUCTION
- Hand unit tooth brush (1)
Never open the hand unit of the toothbrush because the
unit is no longer watertight after it has been opened.
Replace the entire unit in case of a defect.
When discarding the hand unit, remove the built-in
rechargeable battery.
The battery should be completely empty.
Instructions to remove the battery:
1. Pull of the housing.
2. Lift the battery out of the battery holder by means of a
screwdriver.
NiCd
Note: After the housing has been removed, the appliance
may not be watertight anymore and the guarantee will
become invalid.
- Charging stand (2)
In case of a defective charging unit or damaged cord the
complete charging unit must be replaced.
OPTIONAL (accessories)
- No specific issues
PARTS LIST & EXPLODED VIEW
1
2
n
Pos Service code Description
1
2
4203 035 51600
4203 035 53950
4203 035 53980
4203 035 53970
4203 035 53960
Brush
Charging Stand WEU / EEU
Charging Stand UK
Charging Stand KOR
Charging Stand China