Philips HP4857/00 User manual

Thermoprotect super silent 1250
HP4857
/00

2

3
B
G
H
F
A
D
E
C

4

ENGLISH 6
BAHASA MELAYU 13
TI”NG VI◊T 21
 28
34
41
47
HP4857
5

Introduction
The unique Thermoflow System
This new Philips beauty hairdryer has been
specially designed to meet your personal needs.
The Thermoprotect hairdryer features the
innovative Thermoflow System that uses more air
but less heat.This system dries your hair just as
quickly as an ordinary hairdryer without the risk
of dehydration. It preserves your hair's natural
moisture level and leaves your hair with the lustre,
body and richness you love.To get beautiful hair
you need to dry it, not dehydrate it.
General description
AAir inlet grille
BAir outlet grille
CSide buffer
DQuick-Dry setting
EAirflow & on/off switch
FHanging loop
GComb diffuser
HConcentrator
ICare Mode light
ENGLISH6

Important
Read these instructions for use carefully before
using the appliance and save them for future
reference.
◗Check if the voltage indicated on the
appliance corresponds to the local mains
voltage before you connect the appliance.
◗Check the condition of the mains cord
regularly. Do not use the appliance if the plug,
the cord or the appliance itself is damaged.
◗If the mains cord is damaged, it must be
replaced by Philips, a service centre
authorised by Philips or similarly qualified
persons in order to avoid a hazard.
◗Keep this appliance away from water! Do not
use this product near or over water
contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the
appliance after use since the proximity of
water presents a risk, even when the
hairdryer is switched off.
◗For additional protection we advise you to
install a residual current device (RCD) with a
rated residual operating current not
exceeding 30mA in the electrical circuit
supplying the bathroom.Ask your installer for
advice.
◗Keep the appliance out of the reach of
children.
◗Never block the air grilles.
◗If the appliance overheats, it will switch off
automatically. Unplug the appliance and let it
ENGLISH 7

cool down for a few minutes. Before you
switch the appliance on again, check the grilles
to make sure they are not blocked by fluff,
hair, etc.
◗Always switch the appliance off before putting
it down, even if it is only for a moment.
◗Always unplug the appliance after use.
◗Do not wind the mains cord round the
appliance.
Using the appliance
1Put the plug in the wall socket.
C2Switch the appliance on by selecting the
desired setting:
C◗÷: Quick-Dry setting - to dry shower-wet
hair very quickly and safely.
We advise you to use the Quick-Dry setting only
briefly to avoid dehydrating your hair.
The Care Mode light goes out when you select
the Quick-Dry setting.
◗II: Care & Dry setting - strong airflow and
caring temperature for fast but gentle drying.
◗I: Styling setting - low airflow, especially
intended for styling.
The Care Mode light goes on when you select
the Care & Dry setting or the Styling setting to
indicate that you are drying your hair gently.
ENGLISH8
protect

◗O: Off.
3Dry your hair by making brushing
movements while holding the dryer at a
small distance from your hair.
Attachments
Concentrator
The concentrator enables you to direct the
airflow at the brush or comb with which you are
styling your hair.
C1Connect the concentrator by simply
snapping it onto the appliance. Disconnect
it by pulling it off.
Comb diffuser
The diffuser enables you to create volume, a fancy
flick or to simply comb your hair.
C1Connect the diffuser by simply snapping it
onto the appliance. Disconnect it by pulling
it off.
Volume
Use the comb diffuser to add volume at the roots
of your hair.
C1Insert the pins into your hair until they
touch your scalp.
ENGLISH 9

2Start at the lower part of your head and
move upwards slowly. Make rotating
movements with the appliance to disperse
the warm airflow evenly through your hair.
Straight hair
Use the comb diffuser to create a straight
hairstyle.
C1Insert the pins into your hair.
2Start at the upper part of your head and
move the comb downwards slowly.
Cleaning
Always unplug the appliance before cleaning it.
Never rinse the appliance with water.
1The appliance can be cleaned with a dry
cloth.
2The attachments can be cleaned with a
moist cloth or rinsed under a running tap.
Remove the attachments from the appliance
before cleaning them.
Make sure the attachments are dry before using
or storing them.
ENGLISH10