Philips R5505 User manual

DAB+ radio
5000 Series
R5505
User manual
Register your product and get support at
www.philips.com/support

EN 1
Contents
1 Important 2
Safety 2
2 Your FM/DAB radio 3
Introduction 3
What's in the box 3
Overview of the main unit 4
3 Get started 5
Prepare radio antenna 5
Connect power 5
Turn on 5
Adjust the volume level 5
Switch to standby mode 5
4 Listen to DAB radio 6
Tune to DAB radio stations 6
Store DAB radio stations 6
Select a preset DAB radio station 7
Show DAB information 7
Use menu in DAB mode 7
5 Listen to FM radio 8
Tune to FM radio stations 8
Store FM radio stations 8
Select a preset FM radio station 8
Use menu in FM mode 9
Show FM information 9
6 Other features 10
Play audio through Bluetooth 10
Use menu in Bluetooth mode 10
Kitchen Timer 10
Sleep Timer 11
7 Product information 11
8 Troubleshooting 12
9 Notice 13
Compliance 13
Care of the environment 13
Trademark notice 13

EN2
1 Important
Safety
Warning
tNever remove the casing of this radio.
tNever lubricate any part of this radio.
tNever place this radio on other electrical
equipment
tKeep this radio away from direct sunlight, naked
flames or heat
tMake sure that you always have easy access to
the power cord, plug or adaptor to disconnect
the internet radio from the power.
tRead and follow these instructions.
tMake sure that there is enough free space
around the product for ventilation.
tRefer all servicing to qualified service
personnel. Servicing is required when the
radio has been damaged in any way; such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the internet radio, the radio has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
tOnly use attachments/accessories specified
by the manufacturer.
tUse only power supplies listed in the user
manual.
tUnplug this product during lightning storms
or when unused for long periods of time.
tThe product shall not be exposed to
dripping or splashing.
tDo not place any sources of danger on the
product (e.g. liquid filled objects, lighted
candles).
tWhere the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
tDo not use this apparatus near water.
tInstall in accordance with the
manufacturer's instructions.
tDo not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.

EN 3
2 Your FM/DAB
radio
Congratulations on your purchase, and welcome
to Philips! To fully benefit from the support that
Philips oers, register your product at www.
philips.com/welcome.
Introduction
With this radio, you can:
tlisten to FM and Digital Audio Broadcasting
(DAB) radio;
tplay audio from Bluetooth-enabled devices.
What's in the box
Check and identify the contents of your package:
tFM/DAB radio
tPower adapter
tQuick Start Guide
tSafety and Warranty leaflet

EN4
Overview of the main unit
tTurn on the radio.
tSwitch to standby mode.
SOURCE
tSelect a source: Bluetooth, DAB or FM
radio.
INFO/MENU
tPress to display information in FM/
DAB mode.
tIn working mode, press and hold to
access the top menu.
VOL knob
tTurn to adjust volume.
Preset stations (1, 2, 3)
tStore /directly access preset 1, 2, or 3.
PRESET
tStore radio stations.
tDisplay and select preset stations.
tIn Bluetooth mode: Press to skip to
the previous track.
tIn Tuner mode: Tune to a radio
station.
tNavigate through the menu list.
tIn Bluetooth mode: Press to skip to
the next track .
tIn Tuner mode: Tune to a radio
station.
tNavigate through the menu list.
SCAN/SELECT
tPress to confirm a selection.
tPress and hold to auto scan all station
in FM tuner mode.
DISPLAY SCREEN
tShow current status.
Radio antenna
tImprove radio reception.
DC IN
tConnect to the supplied power
adaptor.

EN6
4 Listen to DAB
radio
Tune to DAB radio stations
The first time you select DAB radio mode, or if
the station list is empty, the radio performs a full
scan automatically.
tPress SOURCE repeatedly to select [DAB]
mode.
[Scanning] is displayed.
The radio scans and stores all the DAB
radio stations automatically, and then
broadcasts the first available station.
The station list is memorized in the
radio. Next time when you turn on the
radio, the station scan does not take
place.
To tune to a station from the available station
list:
tIn DAB mode, press to
navigate through the available DAB stations.
Tip
tThe stations may change from time to time.
To update the station list, select the [Full scan]
menu option to perform full scan.
Store DAB radio stations
Note
tYou can store a maximum of 20 preset DAB
radio stations.
1In DAB mode, tune to a DAB radio station.
2Press and hold PRESET for two seconds.
The Preset store is displayed.
3Press to select a preset
number.
4Press Ielect to confirm.
[Preset stored] is displayed.
The station is stoned in the selected
position.
Note
tAt step 2, you can also press and hold preset
key 1, 2 or 3 to save the current station to the
corresponding position directly.
tTo remove a preset DAB radio station, store
another station in its place.

EN 7
Select a preset DAB radio
station
In DAB mode, you have two ways to select a
preset radio station.
Option A:
1Press PRESET.
The Preset Recall is displayed.
2Press to select a preset
number.
3Press to confirm.
Option B:
tPress the numeric key 1-3 directly.
Show DAB information
While listening to DAB radio, press
repeatedly to scroll through the following
information (if available):
Radio mode
Kitchen timer
Sleep timer
Dynamic Label Segment (DLS)
Signal strength
Program type (PTY)
Ensemble Name
Frequency
Signal error rate
Bit rate and audio status
Time
Date
Use menu in DAB mode
1In DAB mode, press and hold to
access DAB menu.
2Press to scroll through the
menu options:
t[Kitchen Timer]: set kitchen timer
t[Full scan]: scan and store all the
available DAB radio stations.
t[Manual tune]: tune to a specific
channel/frequency manually and add it
to the station list.
t[DRC]: compress the dynamic range
of a radio signal, so that the volume
of quiet sounds is increased, and the
volume of loud sounds is reduced.
t[Prune]: remove all the invalid stations
from the station list.
t[Sleep]: set sleep timer
t[Clock]: set time/date, select 12/24
hour; and set time synchronization
t[Backlight]: adjust backlight settings
(3 options: Time out/ On level/ Dim
level)
t[System]: adjust system settings:
t [Language]: set system language
(Engish/ Deutsch/ Italiano/ Francais/
Nederlands/ Norwegian)
t [Factory Reset]: reset the unit
t [SW version]: view software
version
3To select an option, press button.
4Repeat steps 2 to 3 if any sub-option is
available under one option.
t 5PSFUVSOUPUIFQSFWJPVTNFOVQSFTT
.
Note
tIf no button is pressed within 15 seconds, the
menu exits.

EN8
5 Listen to FM
radio
Tune to FM radio stations
1Press SOURCE repeatedly to select [FM]
mode.
2Press and hold for two
second.
The radio tunes to an FM radio station
with strong reception automatically.
3Repeat step 2 to tune to more radio
stations.
To tune to a station manually:
tIn FM tuner mode, press
repeatedly to select a frequency.
Store FM radio stations
Note
tYou can store a maximum of 20 FM radio
stations.
1In FM mode, tune to an FM radio station.
2Press and hold PRESET for two seconds.
The Preset store is displayed.
3Press to select a preset
number.
4Press to confirm.
[Preset stored] is displayed.
The station is stoned in the selected
position.
To store FM radio stations automatically
tRather than manually storing stations, you
can also let the unit automatically store
found stations:
Press and hold button to do auto
scanning for the broadcasting radio
channels, press it again to stop auto
scanning.
Tip
tTo remove a pre-stored station, store another
station in its place.
Select a preset FM radio
station
In FM mode, you have two ways to select a
preset radio station.
Option A:
1Press PRESET.
The Preset Recall is displayed.
2Press to select a preset
number.
3Press to confirm.
Option B:
tPress the numeric key 1-3 directly.

EN 9
Use menu in FM mode
1In FM mode, press and hold to access
FM menu.
2Press to scroll through the
menu options:
t[Kitchen Timer]: set kitchen timer
t[Scan setting]: select the scan sensitivity
(strong stations only and all stations)
t[Sleep]: set sleep timer
t[Clock]: set time/date, select 12/24
hour; and set time synchronization
t[Backlight]: adjust backlight settings
(3 options: Time out/ On level/ Dim
level)
t[System]: adjust system settings:
t[Language]: set system language
(English/ Deutsch/ Italiano/ Francais/
Nederlands/ Norwegian)
t[Factory Reset]: reset the unit
t[SW version]: view software
version
3To select an option, press button.
4Repeat steps 2 to 3 if any sub-option is
available under one option.
tTo return to the previous menu, press
.
Note
tIf no button is pressed within 15 seconds, the
menu exits.
Show FM information
While listening to FM radio, press
repeatedly to scroll through the following
information (if available):
Radio mode
Kitchen timer
Sleep timer
Radio text messages
Program type
Frequency
Time
Date