Philips HP4646/08 User manual

SalonStraight Want2Move
HP4646

2

3
1

4

ENGLISH 6
DEUTSCH 12
FRANÇAIS 18
NEDERLANDS 24
ESPAÑOL 31
ITALIANO 37
PORTUGUÊS 43
NORSK 49
SVENSKA 55
SUOMI 61
DANSK 67
 73
TÜRKÇE 80
HP4646

Introduction
This new Philips SalonStraight Want2Move straightener provides ultra -
fast shiny straight styles, combining professional performance with
purse-size portability.
The ceramic-coated plates ensure ultra-smooth gliding through the hair,
allowing you to style at high temperatures in a quick and caring way.
The slimline design enables you to achieve straightness from the roots
and versatility in styling from pin curls to flicks.
General description (fig. 1)
ACeramic-coated plates
BCool tip area
CSlimline design
DFolding system
EOn/off button with power-on indicator
FEasy-lock system
GSwivel cord with cord holder
HTravel pouch
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
◗Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
◗This appliance is suitable for mains voltages from 100 to 240 volts.
◗Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
◗If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualified persons
in order to avoid a hazard.
◗Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the appliance is
switched off.
ENGLISH6

◗For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
◗Keep the appliance out of the reach of children.
◗The straightening plates and the plastic parts near the plates
(except the cool tip area) reach a high temperature quickly.
Prevent the hot surfaces of the appliance from coming into
contact with your skin.
◗Do not leave the plates in your hair for more than a few seconds
at a time as this may cause damage to your hair.
◗Keep the appliance away from non-heat-resistant surfaces and
never cover the appliance with anything (e.g. a towel or clothing)
when it is hot.
◗Keep the straightening plates clean and free of dust, dirt, styling
spray and gel. Using the appliance in combination with styling
mousse, styling spray, gel etc. may cause damage to the ceramic-
coated straightening plates.
◗The plates have a ceramic coating.This coating will wear in the
course of time.When this happens, the appliance will still function
normally.
◗Always unplug the appliance after use.
◗Wait until the appliance has cooled down before storing it.
Preparing for use
Washing
The straightener gives the best results on well-washed hair.We advise
you to follow the washing tips below.
1When washing your hair, wet your hair thoroughly for
30-60 seconds.
2Pour some shampoo into the palm of your hand. Spread it
between your hands and distribute it evenly through the hair.
3Gently massage your hair and scalp. Do not rough up the hair or
pull long hair up onto the scalp, as this may cause tangles.
ENGLISH 7

4Massage your scalp with your fingertips.This stimulates blood
circulation and is gentler to the hair cuticles.
5Rinse your hair thoroughly, as poor rinsing can result in dull hair.
Finish with a cold rinse for extra shine.
Drying
To get super-smooth results, it is essential to prepare your hair for
straightening. Dry you hair properly with a hairdryer to ensure a
professional, smooth finish.
1After washing, squeeze excess water out of the hair with your
hands and then towel-dry the hair. Use a comb to disentangle hair
gently from the roots to the tips.
2Divide the hair into sections by means of clips, starting at the back.
3Dry each section by pulling a straightening brush down the hair
length while following the brush with the hairdryer, with its
nozzle pointing towards the hair ends.
4When you have finished drying each section, set the hairdryer to
the cold setting for a final cold shot.This closes the cuticles and
leaves your hair looking glossier.
BTip: Philips Salon Pro hairdryers have a lower drying temperature and a
stronger airflow than regular dryers.Thanks to this combination, they dry
just as quickly as regular hairdryers but in a gentler way.
Using the appliance
Straightening
Straighteners are powerful styling tools and should always be used with
care.
As with all straighteners that reach salon high temperatures, do not
use the appliance frequently to avoid damage to the hair. If you use
the straightener incorrectly, you could overheat your hair or even
burn it.Always follow the steps below.
ENGLISH8

1Put the mains plug into the wall socket.
BThis appliance has an internal dual voltage mechanism that
automatically adjusts to the required voltage.Therefore it can easily be
used abroad. Use a plug adapter suitable for the wall sockets in the
country you are visiting to connect the appliance to the mains.
2Unfold the straightener by pushing both folding system buttons
simultaneously (fig. 2).
◗Always make sure the straightener is fully extended when you
use it.
3Unlock the straightening plates by turning the easy-lock system
counterclockwise until the plates open (fig. 3).
4Push the on/off button.The light goes on to indicate that the
straightener is heating up.
The plates heat up rapidly and will be ready for use within seconds.
5Comb or brush your hair so that it is disentangled and smooth.
6Use a comb to divide the hair into sections. Do not put too
much hair in one section (fig. 4).
BTip: it is better to section off the crown area and to straighten the hair
underneath first, followed by the top area.
7Take a section that is approximately 3-4cm wide. Place it between
the straightening plates and press the handles of the appliance
firmly together.
8Slide the straightener down the length of the hair for 5 seconds,
from root to hair end, without stopping to prevent overheating
(fig. 5).
9Repeat this process after 20 seconds until you have achieved the
desired look.
10 Allow your hair to cool down. Do not comb or brush it before it
has cooled down, as this could ruin the hairstyle you have just
created.
ENGLISH 9

◗Always make sure the appliance is either fully extended or
completely folded when not in use.
Cleaning
1Make sure the appliance is switched off and unplugged.
2Let the appliance cool down completely on a heat-resistant
surface.
3Clean the appliance with a damp cloth.
Storage
Never wind the mains cord round the appliance.
1Make sure the appliance is switched off and unplugged.
2Let the appliance cool down on a heat-resistant surface before
storing it.
3Lock the straightening plates by holding the handle and turning
the easy-lock system clockwise (fig. 6).
4Fold the straightener by pressing both folding system buttons
simultaneously (fig. 7).
5Place the folded straightener in the heat resistant pocket of the
pouch for easy portability or storage (fig. 8).
You can use the cord holder to fold the cord and keep it in place.
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
ENGLISH10