Phonak Roger Touchscreen Safety guide

How to Connect with
Roger Touchscreen
General Operation
Device Description
1. On/Off
2. Wake/sleep
3. Indicator light
4. Microphones
5. Mute
6. Touchscreen
7. Micro-USB
8. Jack 3.5 mm/ 1/8
9. Feet
10. Lanyard: clip/remove button
11. Lanyard clip
12. Length adjustment
13. Safety breakaway
• To switch on, press the On/Off button on the side of the
Roger Touchscreen for 3 seconds. The green indicator
lights will flash until fully booted. The power indicator
light will continue to fade in and out green during use.
• To switch off, press the On/Off button on the side of
the Roger Touchscreen for 3 seconds. The indicator
lights will flash green 3 times and then turn off.
• When charging either with a USB power cord or in
the Roger Charging Rack, the indicator lights will flash
green and when fully charged will shine solid green.

Connecting to Computers/Tablets
1. Plug one end of supplied 3.5 mm/ 1/8 “ cable into the
multimedia device’s audio out (i.e. headphone jack).
2. Plug the other end into the Roger Touchscreen
Mic’s 3.5 mm/ 1/8 “ audio jack.
3. Select “input” from the pop up menu on the Touchscreen
4. Select “Headphones” from the pop up
menu on your computer. Figure 1
5. Control volume by clicking on the speaker icon on the
bottom right corner of your computer screen. Figure 2
Figure 1
Figure 2