Page 1.2 10A & 30A SOLID STATE SPST SWITCH 40-182/183
pickering
SECTION 1 - TECHNICAL SPECIFICATION
10 A Solid State SPST Switch, 40-182
pickeringtest.com
Specifications
Switching Specification
Switch Type Solid State MOSFET
Max Switch Voltage:
Continuous Switch Current:
Peak Current:
±200 V* (DC or AC peak)†
10 A
50 A for 200 µs
Max Total Module Current: 6 channels each carrying
10 A ‡
Initial On Path Resistance: 60 mΩ at 25 ˚C typical
Rise/Fall Time:
Operate Time:
Recommended Maximum
Cycle Rate (on, then off):
<12 µs typical
20 µs on, 20 µs off
150 operations/sec
Expected Life (operations): Indefinite when used within
ratings
* For full voltage rating, signal sources to be switched
must be fully isolated from mains supply and safety earth.
† Differential voltage between channels must not exceed
rated voltage, additional caution should be used when
applying AC voltages as multiple asynchronous supplies
can create high differential voltages between channels.
‡ The capacity of the module to carry 10 A on all channels
is chassis dependent and dependent on the number of
high power modules fitted to the chassis. Specification
reflects test conditions in a Pickering PXI chassis. Refer to
supplier for chassis cooling capacity, restrict average RMS
current over 5 minute period to 7 A per channel for chassis
meeting the minimum PXI recommendations.
Power Requirements
+3.3 V +5 V +12 V -12 V
100 mA 560 mA 0 0
Operating/Storage Conditions
Operating Conditions
Operating Temperature:
Humidity:
Altitude:
0 °C to +55 °C
Up to 90 % non-condensing
5000 m
Storage and Transport Conditions
Storage Temperature:
Humidity:
Altitude:
-20 °C to +75 °C
Up to 90 % non-condensing
15000 m
PXI & CompactPCI Compliance
The module is compliant with the PXI Specification 2.2.
Local Bus, Trigger Bus & Star Trigger are not implemented.
Uses a 33 MHz 32-bit backplane interface.
Safety & CE Compliance
All modules are fully CE compliant and meet applicable
EU directives: Low-voltage safety EN61010-1:2010,
EMC Immunity EN61326-1:2013,
Emissions EN55011:2009+A1:2010.
Mechanical Characteristics
40-182-011: Double slot 3U PXI (CompactPCI card).
40-182-012: Single slot 3U PXI (CompactPCI card).
3D models for all versions in a variety of popular file
formats are available on request.
Connectors
PXI bus via 32-bit P1/J1 backplane connector.
Signals via front panel connectors, for pin outs please refer
to the operating manual.
• 40-182-011: 2 x 8-pin male power D-type connectors.
• 40-182-012: 1 x 8-pin male power D-type connector.
Relay Type
The 40-182 is fitted with solid state MOSFET switches.
