Pitsco Education BUILDERSPACES SPACEPORT User manual

79134
BUILDERSPACES SPACEPORT
Assembly Instructions

Content advising by Jason Lee.
SolidWorks® Composer™ renderings by Tim Lankford. Keyshot® cover renders by Jason Redd.
Desktop publishing by Todd McGeorge.
©2020 Pitsco, Inc., 915 E. Jefferson, Pittsburg, KS 66762
All rights reserved. This product and related documentation are protected by copyright and are distributed under licenses
restricting their use, copying, and distribution. No part of this product or related documentation may be reproduced in any
form by any means without prior written authorization of Pitsco, Inc.
All other product names mentioned herein might be the trademarks of their respective owners.
V1.0
06/20
Safety
• Always wear safety glasses when using a drill to tighten screws.
• Keep fingers and loose articles of clothing clear of the drill.
Recommended/Required Tools
• Corded or cordless drill/driver
• Driver bits including #2 Phillips head, 5/32" hex (Confirmat screw), 3/16" hex (Stafast sleeve nut)
• Phillips-head screwdriver

79134
BuilderSpaces SpacePort Tower
Assembly Guide
Tower Assembly BuilderSpaces SpacePort Assembly Instructions
1

6x Countersink Confirmat Screw 20263
4x Table Leg Caster 42075
4x Table Leg Mounting Plate 42076
4x Table Leg 42076
14x Minifix Threaded Stud Connector 11041
14x Minifix Cam 41892
1x Tower Top 43309
1x Tower Bottom 43310
2x Tower Box Side with edge banding 43311
2x Tower Box Side without edge banding 43312
BuilderSpaces SpacePort Tower Parts Overview
Tower Assembly
32x Pan Head Screw (#12 x 3/4") 17352
BuilderSpaces SpacePort Assembly Instructions
2

Step 1 Parts Needed
Step 1.0
6x
Minifix Threaded Stud Connector
11041
1x
Tower Top
43309
Tower Assembly
Note: When installing each Minifix Threaded
Stud Connector (11041), start with low
torque and make sure the bottom of the stud
is flush with the part’s surface.
BuilderSpaces SpacePort Assembly Instructions
3

Detail
Tower Assembly
BuilderSpaces SpacePort Assembly Instructions
4

Step 2 Parts Needed
Step 2.0
Assemble two like this.
Tower Assembly
14x
Minifix Cam
41892
2x
Tower Box Side
without edge banding 43312
2x
Tower Box Side with edge
banding 43311
8x
Minifix Threaded Stud Connector
11041
1x
Tower Bottom
43310
1x
BuilderSpaces SpacePort Tower Top
43309 with Minifix Threaded Stud
Connectors 11041 installed
6x
Countersink Confirmat Screw
20263
BuilderSpaces SpacePort Assembly Instructions
5

Detail 1
Detail 2
Tower Assembly
Note: When installing each Minifix
Cam (41892), make sure the top of
the cam is flush with the tower box
side’s surface and that the arrow is
facing the corresponding hole/side.
BuilderSpaces SpacePort Assembly Instructions
6

Detail
Tower Assembly
Step 2.1
Assemble two like this.
BuilderSpaces SpacePort Assembly Instructions
7

Step 2.2
Tower Assembly
Detail
BuilderSpaces SpacePort Assembly Instructions
8