pitsco The Sand Box User manual

The Sand Box is a sanding table that can be used to sand wood projects in the classroom – it is quiet and
sized for individual student use. With two quiet suction fans to draw away sanding dust, the Sand Box
sanding table also features sturdy aluminum and HDPE construction.
Using The Sand Box
1. Place The Sand Box on a at, stable surface such
as a desk, table, or countertop.
2. Plug The Sand Box cord into a standard 120V wall
outlet. Make sure the lter is in the device with
the arrows on the lter facing down. Using the
switch on the underside of the device, turn it on
(Figure 1).
3. Keeping the item to be sanded over the
corrugated cover of The Sand Box, sand as
normal (Figure 2). The suction created by the
fans will collect the dust into the lter.
The Sand Box User Guide 59791 V0510
Figure 1
User Guide
The Sand
Box

Cleaning/Changing the Filter
It is recommended to use a non-berglass, disposable
furnace lter sized 16" x 20" x 1". Pitsco has
replacement lters available at www.shop-pitsco.com
(Pitsco item 34226). Using other types of lters in The
Sand Box may cause it to work less eectively.
Note that a lter can be reused by following the
instructions below. A new lter should be used when
the old lter no longer collects all the dust.
1. Pull the lter out of The Sand Box where there is a
long opening on the side (Figure 3). If you cannot
grip the lter to remove it, you can push it out from
the other side with the short opening.
2. If you are cleaning the lter, take it outside and
gently knock out the dust. Or, use a vacuum with
a nozzle attachment to remove the dust. If you are
replacing the old lter, simply throw it away and
place the new lter in the slot where you removed
the old one.
Note: Be sure the lter is installed properly with the
arrow pointing down.
The Sand Box User Guide 59791 V0510
P.O. Box 1708 • Pittsburg, KS 66762
www.pitsco.com
Toll-Free Orders 800-835-0686
Figure 3
Figure 2