Plantronics CALISTO User manual

Plantronics®Calisto™Headset
with Bluetooth®USB Adapter
User Guide
56-A11A-10511

ii

iii
Table of Contents
Package Contents................................................................................ 1
Product Features.................................................................................. 2
Wearing The Headset ........................................................................... 3
Powering .............................................................................................. 4
Charging .............................................................................................. 4
Indicator Lights..................................................................................... 6
Pairing .................................................................................................. 7
Computer Audio Settings ..................................................................... 8
Using The Headset............................................................................... 9
Regulatory Notices ............................................................................. 10

1
Package Contents
Calisto
Headset
Bluetooth
Adaptor
USB Headset
Charger

2
Product Features
Indicator Light
USB Connector
Pairing/Connect
Button
Charge Connection
Call Control Button (on/off)
Reversible
Earloop
Noise-
Canceling
Microphone
Volume Adjust

3
The headset can be worn on your left or right ear. To switch from one
ear to the other, flip the ear loop to the side, and twist around.
Wearing the Headset
The ear tip should fit
comfortably in the opening
of your ear canal
Point the mouthpiece toward
your mouth

4
The headset automatically powers up when it is charging.
Powering up: Press and hold Headset button for 2 seconds.
4 ascending beeps will sound when powered on.
Powering down: Press and hold Headset button for 4 seconds.
4 descending beeps will sound when powered off.
NOTE For your convenience, the headset comes pre-paired with
the USB Bluetooth adapter, and (if the headset is within range) will
automatically connect to the adapter when powered on.
The USB Bluetooth adapter is automatically powered on upon inserting
into the USB port of the computer.
Powering Headset & USB Bluetooth
Adapter

5
Charging the Headset
Before using, you must first charge your headset. The indicator light
glows solid red while charging and turns solid blue when the headset is
fully charged.
Charge the headset for a minimum of 2 hours.
Battery talk time is up to 8 hours.
NOTE Do not use headset while chargng and do not connect the
charger while headset is in use.

6
Headset and USB Bluetooth Adapter
Indicators/Alerts
Headset Indicator Lights
Action Button Action Sounds Indicator
Lights
Turn
headset on
Press and hold
for 2 seconds
4 ascending
beeps
Flashes
blue every
10 seconds
Turn
headset off
Press and hold
for 4 seconds
4 descending
beeps
Turn
microphone
on/off
Press for
1 second
1 high
beep
Adjust
volume
Press up or
down (not
inward)
2 beeps
when max/
min volume
reached
Headset Alerts
Alert Sounds Indicator Lights
Low battery 3 beeps
every 30
seconds
Flashes red 3 times every 3
seconds
Charging Glows solid red
Fully charged Glows solid blue while
connected to charger

7
Bluetooth USB Adapter Indicator Lights
Action Indicator Lights
Disconnected from
the headset
Flashes purple
Connected to the headset Solid blue
Radio link active Flashes blue
Pairing mode Flashes red and blue
Pairing Headset with USB Bluetooth
Adapter
NOTE The headset and USB Bluetooth adapter are paired to each
other at the factory. However, if you have purchased a USB Bluetooth
adapter separately, or if you wish to use a replacement headset with
your existing adapter, the units must be paired.
Insert the USB Bluetooth adapter in the USB port of your computer.
2 sec.
1. To put the headset into pairing mode, you must first power the
headset off. You will hear 4 descending beeps when the headset
powers off.
2. Once headset is off, hold down call control button for 4-6 seconds.
3. Release the button when the indicator lights on the headset begin to
flash red then blue.

8
4. To put the USB Bluetooth adapter into pairing mode, Pinch the
pairing/connect button for at least 2 seconds until adapter flashes red
and blue and begin pairing with your Bluetooth headset.
5. When both USB adapter and headset are in pairing mode, and within
30 feet of each other, they should connect.
6. The USB adapter show a solid blue light when connected to the
headset.
NOTE Take caution when manually pairing the USB adapter. Do not
press hard. Please “pinch” with both fingers rather than push on the
adapter to avoid damage to the adapter or USB port.
Adjusting Computer Audio Settings
1. On your PC, launch the Sound and Audio Devices from the control
panel button and select the Audio tab.
2. Under Sound Playback and Sound Recording default devices,
make sure Plantronics Bluetooth Adapter is selected.
3. Press OK.
Using the Headset
Placing/Answering/Ending calls with your softphone:
1. To make a call, simply dial the number via your softphone application
and press the headset button for under 1 second to transfer audio
into the headset.
2. To answer or end a call, press the call control button for under 1
second.
For other audio applications on computer:
1. Pressing the headset button for under 1 second will turn microphone
on/off.

9
Using the Headset with Dragon
NaturallySpeaking and Dragon
Medical
When creating a new user within Dragon using your headset, note the
following:
1. On the first screen of the New User Wizard, make sure to select
Bluetooth Microphone from the Dictation Source list.
2. If Dragon prompts you to Choose your sound system, make sure to
pick Plantronics BT Adapter from the list and then click Next to
continue setting up your user.

Regulatory Notices
FCC Requirements Part 15
This device complies with part 15 of the FCC Rules subpart B. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
EXPOSURE TO RF RADIATION
The internal wireless radio operates within the guidelines found in radio frequency safety
standards and recommendations, which reflect the consensus of the scientific commu-
nity. Independent studies have shown that the internal wireless radio is safe for use by
consumers.
Visit www.plantronics.com for more information.
Industry Canada Notice
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Headset: BlueMax (BUA-100):
Model:B70 IC: 457A-BUA100
For IC: 457A-E3XX FCC ID: AL8BUA-100
For FCC ID: AL8-E3XX

© 2008 Plantronics, Inc. All rights reserved. Plantronics, the logo design, Calisto, and
Sound Innovation are trademarks or registered trademarks of Plantronics, Inc. The
Bluetooth® word mark is owned by Bluetooth SIG,Inc., and any use of the mark by
Plantronics, Inc. is under license
56-A11A-10511 (07.08)