Playskool Around Town Activity Center 06032 User manual

OVER 12 months
06032
Thank you for choosing this unique activity toy!
Inc udes 4 x 1.5V "D"/R20 batteries. A ka ine
batteries recommended. Phi ips/crosshead
screwdriver (not inc uded) required for battery
insta ation.
Around Town
Activity Center™
Around Town
Activity Center™

PLAY FEATURES
PLEASE NOTE: This product is shipped in "Demo" mode. Slide switch
on back o toy to "On" or ull use at home.
The AROUND TOWN ACTIVITY CENTER set eatures lots o air-
powered activities and happy music to amuse and ascinate
your toddler! To activate the toy, push the radar dish, move the ire
hydrant, move the train gate, or push the elevator button.
MMuussiicc ttoo mmaattcchh tthhee
ddiieerreenntt aaccttiivviittiieess!!
HHeelliiccoopptteerr’’ss bbllaaddee
rroottaatteess!! CCaarr’’ss
hheeaaddlliigghhttss ttwwiirrll!!
SSlliiddee tthhee iirree hhyyddrraanntt ttoo
sseeee tthhee ddoooorr rreevvoollvvee!!
PPrreessss tthhee bbuuttttoonn
ttoo mmaakkee cclloocckk ttuurrnn
aanndd eelleevvaattoorr ggoo uupp
aanndd ddoowwnn!!
LLoowweerr tthhee ggaattee ttoo
wwaattcchh tthhee ttrraaiinn ggoo
‘‘rroouunndd aanndd ‘‘rroouunndd!!
RRaaiissee tthhee ggaattee ttoo
ssttoopp tthhee ttrraaiinn..
CChhaarraacctteerrss rriiddee iinn
tthhee vveehhiicclleess!!
PPllaaccee cchhaarraacctteerrss oonn
aannyy yyeellllooww cciirrccllee
oorr aa uunn ssppiinnnniinngg
eeaattuurree!!
33 ccoolloorruull
cchhaarraacctteerrss aanndd ttwwoo
vveehhiicclleess iinncclluuddeedd!!
CCoonnvveenniieenntt
ccaarrrryy hhaannddllee!!
When one or more air-powered activity unctions improperly (though others
may work properly), you will need to replace the batteries.
IMPORTANT NOTE:
VVeehhiicclleess iitt oonn eeiitthheerr oo
tthheessee 22 yyeellllooww cciirrcclleess!!

TO REPLACE BATTERIES
Use a Phillips/crosshead
screwdriver to loosen screws in
battery compartment door
(screws remains attached to
door). Remove and discard old
batteries. Insert 4 resh "D"/LR20
(1.5V) alkaline batteries. Replace
door and tighten screws.
CAUTION: TO AVOID BATTERY LEAKAGE
1) Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers' instructions;
2) Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3) Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
When storing toy, turn the switch to OFF to prevent accidenta
activation.

© 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
06032 P/N 6227400100
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-PLAYSKL
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.