N L 1 2
L
N
L
tc
LED
Load (CC)
150 mA 1–4 W
350 mA 1–9 W
500 mA 1–10 W
700 mA 1–10 W
Install the product in the appliance box behind the
push button/box lid or secure it with a Mounting clip
(MNT-01, not included) on the wall or DIN rail.
When installing in insulated or warm environments or
with several switches in the same box, the total power
is reduced.
Note that the LED load is non-dimmable until the LED-10
is configured. The load is set at low light level, 20 mA until
the product is configured.
Constant current loads (CC) are connected in series.
Constant voltage loads (CV) are connected in parallel.
Use only for LED loads (DC).
tcmarks the point with the highest temperature,
85 °C, at a maximum of 35 °C room temperature.
Load (CV)
12 V (DC) 0–8 W
24 V (DC) 0–10 W
Connect the product
Control inputs 1 and 2 can be used for control using:
- Push button (preset)
- Light switch
- Motion sensor (with neutral conductor)
The inputs can also be used to wirelessly control one
or more products from Plejd. A double click can be used
to activate lighting scenes.
The settings are easy to adjust in the app.
Support
Download the app and follow the instructions
Hand over the Plejd system
Hand over the Plejd system to your customer by writing
the system code on the included sticker . You’ll find the
code in the app once you have completed the installation.
Place the sticker in the distribution box and give the
welcome folder to the customer.
In the event of any technical questions, please contact
Plejd customer service.
HI!
1
2
3
Download the Plejd app via the App Store or Google Play.
After supplying power to the unit by following the relevant
wiring diagram, use the app to complete the installation.
This requires Internet connection and Bluetooth®on your
phone/tablet. You do not need any additional equipment
to get started.
It’s simple to configure all relevant settings in the Plejd app.
The app can be used to schedule the lighting using the
astro/time schedule, control lighting, and wirelessly sync
control switches and scenes.
NOTE!
During installation the product is non-dimmable.
Use the app to configure before use.
Control inputs 1 2
