LED-75 is a LED Driver for 12/24 V DC up to 75 W load. It
has a built-in dimmer and tunable white support for
LED-strips with common anode. The load output is isolated
from the mains voltage (SELV).
The product can be installed on a wall with two screws
(not included).
Connect the product
NOTE!
During installation the product is non-dimmable.
Use the app to configure before use.
If the load isn’t tunable, you may connect it to
either of the negative (-) terminals.
N
N
L
L
1
Cold
Warm
+––
Load (CV)
12 V DC 1–40 W
24 V DC 1–75 W
Control input
Control input 1 can be used for control with:
· push button (preset)
· light switch
· motion sensor (with neutral conductor).
The input can also be used to wirelessly control one
or more products from Plejd. For example, double click
on a push button can be used to activate lighting scenes.
1
Support
Follow the instructions in the app
Hand over the Plejd system
Hand over the Plejd system to your customer by
writing the system code on the included sticker .
You will find the code in the app once you have
completed the installation.
Place the sticker in the distribution box and give
the welcome folder HI! to the customer.
In the event of any technical questions, please contact
our customer service:
Download the Plejd app on the App Store or
Google Play.
After supplying power to the unit by following
the wiring diagram, use the app to complete
the installation. Setup requires Bluetooth®and
an internet connection. You do not need any
additional equipment to get started. It is simple
to configure all settings in the Plejd app.
