Install the product in the appliance box behind the
push button/box lid or secure it with a Mounting clip
(MNT-01, not included) on the wall or DIN rail.
When installing in insulated or warm environments or
with several dimmers in the same box, the total power
is reduced.
Note that the LED load is non-dimmable until the
LED-10 is configured. The load is set at low light
level, 20 mA, until the product is configured.
Constant current loads (CC) are connected in series.
Constant voltage loads (CV) are connected in parallel.
tcmarks the point with the highest temperature,
85 °C, at a maximum of 35 °C room temperature.
Use only for LED loads (DC).
Connect the product
NOTE!
During installation the product is non-dimmable.
Use the app to configure before use.
N L 1 2
L
N
L
tc
LED
Load (CC)
150 mA 1–4 W
350 mA 1–9 W
500 mA 1–10 W
700 mA 1–10 W
Load (CV)
12 V DC 0–8 W
24 V DC 0–10 W
Control inputs 1 and 2 can be used for control with:
· push button (preset)
· light switch
· motion sensor (with neutral conductor).
The inputs can also be used to wirelessly control one
or more products from Plejd. Additionally, double click
on a push button can be used to activate scenes.
Control inputs 1 2
Support
Follow the instructions in the app
Hand over the Plejd system
Hand over the Plejd system to your customer by
writing the system code on the included sticker .
You will find the code in the app once you have
completed the installation.
Place the sticker in the distribution box and give
the welcome folder HI! to the customer.
In the event of any technical questions,
please contact our customer service:
Download the Plejd app on the App Store or
Google Play.
After supplying power to the unit by following
the wiring diagram, use the app to complete
the installation. Setup requires Bluetooth®and
an internet connection. You do not need any
additional equipment to get started. Use the
app to easily configure all settings.
