PMV Mounts PMVCEILINGSMALL User manual

Attach mount to ceiling
Attach pole
1
2
TV Fixing Kit
Mount Assembly Kit
NOTE:
ŸIf in any doubt of the suitability of the
ceiling, it's construction or what type of
fixings to use, consult a qualified builder or
installer.
NOTE:
ŸDo not over-tighten bolt 'A' shown in Stage 2b above.
ŸWhen inserting Grub Screws 'F' as shown in Stage 2c above, insert finger-
tight so all screws are at an equal depth against inner pole. Then tighten
with allen key. Do not over-tighten these Grub Screws.
Ceiling plate
assembly
TV VESA
mounting plate
Tilt / Swivel
Assembly
1m Pole
G - M4 x 16mm
H - M5 x 16mm
I - M6 x 16mm
J - M5 Washer
A - M8 x 75mm Bolt
B - M8 Nut
C - M8 washer
D - M6 x 12mm Bolt
E - M6 washer
F - M6 Grub Screw
K - M5 x 10mm
L - M5 x 10mm
Also Required
x2
x2
x4
x2
x2
x8
x4
x4
x6
x6
ab c
A
B
F
C
x4
ŸRead these instructions carefully before installing your equipment.
ŸInstall the mount in a suitable location using fixings which are appropriate for
the ceiling material and structure. Consult a qualified builder if you’re in any doubt as
to the structural integrity of the ceiling.
ŸDo not attempt to alter or modify any part of the ceiling mount or its attachments.
ŸDo not use if any parts are broken or appear to be damaged.
ŸTighten all bolts and fixings securely. Only use fixings provided with this bracket.
ŸDo not mount your TV close to sources or heat or moisture.
ŸAlways have a minimum of two persons to install the TV on to the mount.
pmvmounts.co.uk
Mounting instructions for universal 1metre TV ceiling mount.
Fits to flat ceiling, cable management through mounting pole.
Maximum TV fixing points up to 400mm x 300mm - Up to 35Kgs
Model No.
PMVCEILINGSMALL
Factory No.
Z3255CMVESA

Attach TV to
Mounting plate
Attach TV Mount
tilt assembly
Attach TV
Assembly to pole
3 4 5
a a
b
c
b
c
Note:
Follow notes as in Stage 2.
Note:
Adjust to full tilt to allow proper mount as per step 5
Note:
For fixing points larger than 200mm x 200mm use the extension arms provided.
Attach the extension arms to the TV plate as shown below.
Fix the top extension arms to the top two TV fixing holes and move the bottom
arms to line up with the bottom two TV fixing holes.
D
E
A
C
B
L
x4
x2
x4
F
x4
K
J
x6
x4
x4
G - I

Fine adjustment of
level and position
Shortening main
pole
6 7
To adjust the forwards/backwards tilt of the TV loosen bolts 'a' and 'b' on both sides of mount.
Re-position TV to desired position and then re-tighten bolts 'a' and 'b’ on both sides of mount'.
To adjust sideways tilt loosen bolts 'c' on both sides of tilt plate, re-position TV to desired
position and then re-tighten bolts 'c' on both sides of tilt plate.
To adjust lateral direction rotate the tilt plate assembly as required.
ab
c
a
b
c
Cut pole
from top
Re-drill 9mm hole
through approx
30mm from pole top
Assemble pole as described
in Stage 2.