PMV Mounts PMVMOUNTXFBPT User manual

Mount Bracket To Wall Secure tilting arms
1 2
NOTE:
For ease of installation mount bracket on wall using position 1 and mark
other positions using a spirit level. Then remove fixing from position 1,
remove bracket and drill other positions.
Use Fixings suitable for your type of wall construction. (Not included).
Use All available fixing points.
If in any doubt of the suitability of the wall, it's construction or what type of
fixings to use, consult a qualified builder or installer.
TV Fixing KitTV Fixing Kit
J - M6 x 20mm
D - M8 x 50mm
A - M6 x 30mm
B - M6 x 50mm
C - M8 x 30mm
H - M8 x 6mm
I - M8 x 12.5mm
F - M8 x 6.5mm
G - M6 x 6.5mm
E - M8
X4
X4
X4
X4
X2
pmvmounts.co.uk
ŸRead these instructions carefully before installing your equipment.
ŸInstall the wall bracket in a suitable location using fixings which are appropriate for
the wall material and structure. Consult a qualified builder if you’re in any doubt as
to the structural integrity of the wall.
ŸDo not attempt to alter or modify any part of the wall mount or its attachments.
ŸDo not use if any parts are broken or appear to be damaged.
ŸTighten all bolts and fixings securely. Only use fixings provided with this bracket.
ŸDo not mount your TV close to sources or heat or moisture.
ŸAlways have a minimum of two persons to install the wall bracket and TV.
Mounting instructions for XL Universal Tilting PORTRAIT wall TV bracket.
VESA 200/300/400/600x400/600 - Universal up to 650mm X 650mm
52" to 90" (132cm to 229cm) - Up to 135Kgs
Model No.
PMVMOUNTXFBPT
Factory No.
Z0840XWPT
Although the tilting arms are assembled with
the retaining bolt in place, ensure it is in
position and adequately tight before further
bracket assembly.
One bolt per arm on outer side.
1

Hang And Secure Screen On
TV Mounting Plate
5
3Attach tilting arms to screen.
A-I x4
Spacers ‘G’ to ‘I’ can be used between the TV
and bracket where the TV rear panel is not flat
or where extra depth is required for cable access.
They can also be used on the screw head side
to adapt screws to shorter lengths.
Stepped spacers fit into the holes on each
mounting arm on either the TV or bracket side.
A Lift TV in to position, bring the bottom of the TV away from the wall and tilt the
top edge in to allow the arms to hook over the wall plate.
B Insert fixing screws J
Additional Padlocks can also be added to either or both arms.
Landscape Portrait
F- I x4
A-Dx4
Ex4
B
A
Jx2
Jx2
6Tilt adjustment
6A - The screen should be supported in its
upright position by an additional person.
6B - Loosen the tilt adjustment allen bolts
on both mounting arms.
6C - Remove retaining pozi drive screw
from both mounting arms.
6D - Lower the tilt angle of the screen to
desired level and tighten one adjustment
allen bolt followed by the other making sure
the angle of both mounting arms is the same.
Note: When screens are extra large or the
VESA mounting pattern is small relative to the
screen the use of extra long tools would aid
installation.
Tilt adjustment
allen bolt
Pozi drive
retaining screw
Two persons should be present to adjust the tilt angle
of the screen and bracket.