Postal Pro Hampton PP300 User manual

24"
24"
Mailbox
Body
Mailbox
Door
(2) Mailbox Pins
Newspaper
Rear Door
Newspaper
Port
Installation Instructions
The Hampton Mailbox and Post Kit
WARNING: “Call Before You Dig” – Dial 811.
811 is the designated “call before you dig” phone number that directly
connects you to your local One Call center. Each state has different
rules and regulations governing digging to insure that buried utility
lines will not be disturbed.
* PLEASE NOTE: Concrete may be needed if installing in loose soil
RECOMMENDED TOOLS & SUPPLIES
• POST HOLE DIGGER
• POST LEVEL OR STANDARD LEVEL
• PHILIPS HEAD POWER SCREWDRIVER
• HAMMER / RUBBER MALLET
• PRESSURE TREATED 4" x 4" x 48" WOODEN POST*
(Not Included) Actual Diameter of a Standard 4" x 4" Pressure Treated
Post: 3-1/2" x 3-1/2"
PARTS LIST
Model: PP300
HARDWARE
Shown at actual size
(4) #12 x 1" Phillips
Self Tap Screws
(4) #10 – 24 x 1-1/2" Phillips
Machine Bolts
(4) #10 – 24 Nuts
Post
Sleeve
A
B
C
READ ENTIRE INSTRUCTION SHEET BEFORE
BEGINNING PROJECT
STEP 1 Determine location for mailbox. Using post hole digger, dig a hole
24" in depth. Install treated pine post by burying 24" of the post in the
ground - leaving at least 24" of post above ground. Use level to ensure
treated pine post is in correct vertical position. Stabilize the treated pine
post by rmly tamping down loose soil around post base.
NOTE: Customers are required to
contact the local post oce before
installing the mailbox to ensure its
correct placement and height at
the street. Generally, mailboxes are
installed at the height of 41–45 inches
from the road surface to inside oor
of mailbox or point of mail entry
(locked designs) and are set back
6–8 inches from front face of curb or
road edge to the mailbox door.

STEP 2 Slide Mailbox Post Sleeve over 4x4
treated pine post. Make sure the mounting arm
is pointing toward the street.
STEP 5 Install Rear Door of Newspaper Port by
snapping pegs into the back indentations of the
Newspaper port. Installing the mailbox will create
a tight hold on the rear door.
STEP 3 Secure the Mailbox Post Sleeve
section to the 4x4 treated pine post using
the (4) #12 x 1" screws Cincluded in the kit.
Screws will go through the plastic with slight
pressure. Do not over tighten.
STEP 6 Assemble your mailbox by using (2) pins
to attach Mailbox Door to holes in Mailbox Body.
Pins can be snapped into place by pressing rmly
with thumb or tapped in using a rubber mallet.
TIP: Make sure the pins are fully snapped into
place. If they are installed correctly, you will not
be able to remove the pins with your ngers.
TIP: Holes in door should be positioned outside
of holes on mailbox body before insertion of pins.
STEP 4 Snap Newspaper Port to top of Mailbox
Post Sleeve.
STEP 7 Place Mailbox on to top of Newspaper
Port, align holes of mailbox & newspaper port and
secure with (4) 24 x 1-1/2" Phillips Machine Bolts A
and nuts B.
C
A
Postal Pro is a Creative Solutions, LLC Product
Manufactured in Purvis, MS
Customer Service 877-544-5220
[e-mail]
www.postalpromailboxes.com
06/22