PotteryBarn Equestrian Wall Mirror User guide

P: 1 / 2
Equestrian Wall Mirror
Mounting Instruction
Note: The hardware provided is meant for dry wall/studmountingonly. If walls areconcrete, brick or plaster, please
consultyour local hardware store for assistance. The mirror is supported using the twokeyhole plates pre-secured on
the back ofthe mirror. Themetal loop ofthemirroris meant for decorative use only and it should not support the weight
of the mirror.
PARTS INCLUDED:
(A) Mirrorx 1 (B) Metal Screwx 3 (C) Drywall Anchorx 3
(D) Mounting Knob x 1 (E) End Cap x 1 (F) Paper Template x 1
TOOLS REQUIRED:
PhillipsScrewdriver, Pencil, Tape Measure, Level, Stud-finder.
MOUNTING INSTRUCTIONS:
1) Determine a desired mounting location for the mirror. Placethe provided paper template on
the wall and using a carpenter’s level to ensure a level installation. Using a pencil, mark the
wall through the template at each screw mark. Remove the template, the resulting marks on
the wall are the insertion locations for the mounting hardware.
2) Use astud-finder to determine if there is a wallstud located at either insertion mark. Install the
proper hardware, as following.
- Dry Wall Installation (diagram shown on the right):
Using a Phillips screwdriver to engage an anchor (C), press the anchor tip against the wall at
insertion mark. Driver the anchorinto the wall (turn the anchor clockwise while applying an
even pressure on it) until its head is flush with the wall surface. Do not over-tighten.
Insert a screw(B) into each installed anchor and rotate with the screwdriver. Leave the screw
head about 3/8 inch protruded from the wall.
- Wood Stud Installation (diagramshown below):
If any ofthe insertion marks aligns with a wall stud, use the Phillips screwdriver to secure the
screw (B) directly into the wall andstud. Same, leave the screw head about 3/8 inch protruded
from the wall.
B
Stud
Stud

P: 2 / 2
3) Once bothscrews are secured in place, raise the mirroragainst the wall and align the twokeyholes over the screw
heads and then slide the mirror down until the keyholes are engaged with the screws. The mirror now should be fully
supported by the screws.
4) Hand the mirror’s loop up and mark location of mounting knob (D). Refer to step#2 for installing the other anchor.
Once installed, position the mounting knob over the anchorand secure usingscrew(B), tighten firmly. (Fig.1)
5) Attach the metal loop onto mountingknob (Fig.2) and fasten the end cap (E). (Fig3)
Fig.1 Fig.2 Fig.3
CARE INSTRUCTIONS:
Wipe with asoft, drycloth. To protect the finish, donot use housecleaners or abrasives.
A household glass cleaner may be used for themirror surface –spray the cleaner on aclean cloth first and then
use the cloth to clean the mirror.
Thank you for your purchase.
Stores | Catalog |www.potterybarn.com