PotteryBarn STAFFORD User manual

Date: 12-JAN-16 www. potterybarn.com Page 1 of 6
Rev:
STAFFORD DINING TABLE

Date: 12-JAN-16 www. potterybarn.com Page 2 of 6
Rev:
Important Safety Instructions:
Please read all instructions carefully before assembling.
For your safety, assembly by two or more adults is strongly recommended.
Keep instructions for future use.
Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
Pre-assembly:
Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as
this will avoid damaging parts during assembly. The shipping box provides an ideal work surface.
Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
Use the parts and hardware lists below to identify and separate each of the pieces included.
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
The use of power tools to aid in assembly is not recommended. Power tools can damage hardware and split
wood.
Parts Included:
(A)
Table Top
1x
(B)
Leaf
2x
(C)
Leg Frame
2x
(D)
Bottom Rail
1x
Hardware Included:
(E)
Flat Washer
Dia. 5/16”x1”
(F)
Spring Washer
Dia. 5/16”
(G)
Long Bolt
Dia. 5/16”x2 1/2”L
8x
8x
8x
Tools Required (included):
(H) Allen Key 5mm

Date: 12-JAN-16 www. potterybarn.com Page 3 of 6
Rev:
Assembly Instruction Steps:
1. Attach Bottom rail (D) to the Leg Frame (C) using the Bolt (G), Spring Washer (F) and Flat Washer (E), and
then securely tighten the bolt with Allen Key (H). Attach the other Leg Frame (C).
2. Carefully turn the Table Top (A) upside down on soft, scratch-free surface such as a carpet or rug. Attach the
Leg to top panel using the Bolt (G), Spring Washer (F) and Flat Washer (E), and then securely tighten all bolts
with Allen Key (H).

Date: 12-JAN-16 www. potterybarn.com Page 4 of 6
Rev:
3. To extend the table: open the hasp under the Table Top (A), pull out the edge of the Table Top (A). Insert the
Leaf (B).
For easy assembly, push the Leaf (B) into end of the table. Slide the end of the table and leaf in to the table top to
close the gap. Once in place, lock the hasp by turning clockwise.

Date: 12-JAN-16 www. potterybarn.com Page 5 of 6
Rev:
4. To take the leaf out: open the hasp under the Table Top (A), pull out the edge of the Table Top (A), take out
the Leaf (B), push to close gap and then lock the hasp, turning clockwise.

Date: 12-JAN-16 www. potterybarn.com Page 6 of 6
Rev:
Adjusting the levelers:
Due to an uneven floor, the furniture may not sit level due causing it to wobble. If the furniture wobbles, determine
which corner does not touch the ground correctly. With two people follow these steps:
1. Carefully elevate the item slightly to provide access to the levelers attached to the bottom.
2. Turn the levelers until adequate contact will be made with the floor. Gently set down the piece and check
stability.
3. Repeat steps until furniture sits firmly on the ground.
Care Instructions:
Dust often using a clean, soft, dry and lint-free cloth.
Blot spills immediately and wipe with a clean, damp, cloth.
We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Thank you for your purchase
Stores | catalog