PotteryBarn Chloe User manual

1/5
Chloe Side Table
Assembly Instructions
Pre-Assembly:
•Please read all instructions carefully before
beginning assembly
•This table requires two people to do the assembly.
•Do not fully tighten all bolts until all parts are in
place. Failure to follow these instructions may
cause the bolts to misalign or may cause difficulty
during assembly.
•Use the parts and hardware lists to identify and
separate each of the components included.
•Save all packing materials until the table is fully
assembled to avoid accidentally discarding any
small parts or hardware.
Parts Included:
(1) Tabletop -A (1) Shelf -B (4) Legs -C
Hardware Included:
(12) Flat Washer - D (12) Lock Washer - E (8) Allen Head Bolt
(M6 x 50 mm) - F
(1) Allen Key - G
(4) Fitting - H (4) Nut - I (1) Allen Wrench (3mm
thickness) - J

2/5
Assembly Instructions:
1. Carefully place the tabletop (A) upside down on a carpeted or scratch-free work surface. (Fig. 1)
2. Attach one leg (C) to the tabletop (A). Insert a lock washer (E) and a flat washer (D) into each Allen bolt (F). Insert
(2) Allen bolts with washers through the pre-drilled holes on the apron and into the leg. Use hand to screw half way
then use the Allen key (G) to continue tightening. DO NOT FULLY TIGHTEN AT THIS TIME. (Fig. 1)
Tighten
Loosen
A
C
3. Attach the pre-attached bolt on the lower part of the leg into the pre-drilled hole of the shelf (B). (Fig. 2)
A
B
C
Loosen Tighten
Fi
g
. 1
Fi
g
. 2

3/5
4. Attach the remaining legs (C) to the tabletop (A) and the shelf (B). (Fig. 3, 4, & 5)
CC
Fi
g
. 3
Fi
g
. 4
Fi
g
. 5

4/5
5. Insert (2) Allen bolts with washers through the pre-drilled holes on the tabletop (A) apron and into the leg. Use hand
to screw half way then use the Allen key (G) to continue tightening but do not fully tighten at this time. Repeat for
the remaining corners of the tabletop (A). (Fig. 6)
6. Insert fittings (H) over the hanger bolt at the four corners of the shelf (B) followed by a flat washer (D), a lock washer
(E) and a nut (I). Tighten with the Allen wrench (J). (Fig. 7)
Fi
g
. 6
Fi
g
. 7
Loosen Ti
g
hten
Use the long end of the Allen
key for easy securing
Loosen Ti
g
hten

5/5
7. Tighten and secure all connections. Grip the table on both ends and carefully turn upright. (Fig. 8)
8. Assembly is complete. (Fig. 9)
Care Instructions:
•For daily cleaning, wipe with a soft damp cloth.
•Wipe up spills immediately.
•Avoid the use of chemicals and harsh cleaning agents.
•The use of trivets and coasters is recommended to protect the tabletop.
thank you for your purchase
stores | catalog | www.potterybarn.com
Fi
g
. 8
Fi
g
. 9