Power Fist 8985988 User manual

V1.0 8985988
Please read and understandall instructions before use. Retainthis manual for
future reference.

8985988 6-1/2 x 6-1/2 ft Rooftop Rack with Awning V1.0
2 For technical questions call 1-800-665-8685
SPECIFICATIONS
Overall Dimensions
6-1/2 x 6-1/2 ft
Material Nylon oxford, aluminum alloy rack
Colour/Finish
Khaki/water resistant coating
Mounting Screw
Adjustment Range (in.) 41 to 78.7
Includes Mounting hardware
WARNING AND SAFETY INFORMATION
•Do not attempt to set up awning in windy conditions.
•All guy ropes must be attached and pegged to the ground at all times.
•Guy ropes are trip hazards in the day and night.
•Keep all flame and heat sources away from the awning.
•Under no circumstance should any naked flame sources or heating
devices be used under or near the awning.
•Look out for any airborne burning embers that may come into contact
with the awning.
•Do not operate any device that burns fuel inside of the awning.
•Keep exit clear during trips.
•Regularly check that all nuts and bolts are attached to your vehicle
tightly and in good condition.

V1.0 6-1/2 x 6-1/2 ft Rooftop Rack with Awning 8985988
Visit www.princessauto.com for m or e in for ma ti on 3
INSTALLATION
1. Slide the small bolts into the mounting rail of the awning.
2. Raise the awning and align into the position of the shorter part of
the L bracket.
3. Screw together with supplied bolts.
4. Check all nuts and bolts periodically.
NOTICE!Put a soft clothor cushion abovethe mounting area to avoid any
potential damageto your car during installation. Use hardwareas per
different car models. Install L brackets on the rails, roof rack or cross bars.
(Additional hardware is supplied for installation on various car m odels.)

8985988 6-1/2 x 6-1/2 ft Rooftop Rack with Awning V1.0
4 For technical questions call 1-800-665-8685
SET UP INSTRUCTIONS

V1.0 6-1/2 x 6-1/2 ft Rooftop Rack with Awning 8985988
Visit www.princessauto.com for m or e in for ma ti on 5
1. Undo the zip on the PVC bag, and release the buckles that hold the
awning in place.
2. Unfold the awning to its full length.
3. Release the legs of awning to desired height and tighten the locator.
4. Release the rafter arms of the awning and insert it into mounting holes.
Tighten the locator.
5. Secure the fabric to the rafter arms using the hook and loop fasteners.
6. Peg the legs to the ground using the rope loops in the feet and guy rope
to secure in case of winds.
A. 4 pc L-bracket
B. 8 pc Long bolts
C. 8 pc Short bolts
D. 8 pc Long bracket clamps
E. 2 pc Short bracket clamps
F. 2 pc Spanners
G. 1 pc Storage bag
H. 2 pc Pegs
I. 2 pc Guy ropes