Power Max PMMC-07 User manual
MODEL:PMMC-07
0501470-Rev1.0
PRIOR TO USE, READ AND UNDERSTAND
PRODUCT SAFETY INFORMATION.
Failure to follow the instructions may result in ELECTRICAL
SHOCK, EXPLOSION, or FIRE, which may result in SERIOUS
INJURY, DEATH, DAMAGE TO DEVICE or PROPERTY.
Do not discard this information.
11 STAGE AUTOMATIC
SMART CHARGER
7.2A 6/12V Car, Motorcycle & Marine
Supply Mode 13.6V
Using 13.6V Supply.
（）
About PMMC-07
01010101
CAUTION: Personal Safety
IMPORTANT SAFETY INFORMATION
02
03
RISK OF EXPLOSIVE GASES.
WARNING: Explosion and Fire Hazard
04
INSTRUCTION MANUAL
05
CHOOSE THE GROUND SYSTEM YOU WILL USE AND
FOLLOW THE STEPS
CAUTION:
AFTER COMPLETING STEPS 1-2 FROM CHOSEN
GROUND SYSTEM, CONTINUE TO 3-4
B. CHARGING BATTERY INSTALLED IN VEHICLE
C. CHARGING BATTERY REMOVED FROM VEHCILE
Note: Connect and disconnect the DC output clamps ONLY AFTER removing the
AC plug from the electrical outlet. Never allow the DC output clamps to touch
each other. This may cause a spark.
06
Charging Modes
Failure Display
Voltage or Failure Code Display
LCD Display Manual
* Keep pressing the Mode buon for more than 3 seconds, you can change
between and .
.
a
a
a
e
e
e
Failure Display
Voltage or Failure Code Display
07
It is important to understand the differences and purpose of each charge mode
and baery type.Do not operate the charger unl you confirm the appropriate
charge mode and baery type for your baery.
08
Using 12V Repair
6V 12V
CAUTION:
" " means that the charger is repairing the baery. If the baery is sll faulty
aer several repairs, the LCD will display "FAIL". If the baery is repired successfully,
the charging process will connue.
09
MALFUNCTIONS AND SOLUTIONS
Cause
macally determine whether the baery is dead. If the baery voltage can be
maintained within a few minutes, indicang that the baery is good, the charger
will automacally enter the floang charge stage. If the baery voltage cannot be
maintained and the voltage is lower than the set value within a few minutes, the
charger will automacally enter the repair mode. Aer the repair is completed, the
charger will connue to charge the baery again. If there are sll problems aer
repairing, the charger will display a malfuncon symbol.
* CHE (a short form of CHECK) is a special funcon for the charger to auto-
10
TECHNICAL SPECIFICATIONS
* Back current drain is the current that drains the baery if the charger is not
connected to the mains. Baery chargers has a very low back current.
This manual suits for next models
1
Table of contents
Other Power Max Batteries Charger manuals
